AQ4140_61 IFU 1/10/08 13:44 Page 1 Radio Cassette Recorder Register your product and get support at www.philips.
AQ4140_61 IFU 1/10/08 13:44 Page 2 CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.
AQ4140_61 IFU 1/10/08 13:44 Page 3 1 3
AQ4140_61 IFU 1/10/08 13:44 Page 4 Korean Controls/Power Supply Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Supplied accessories – AC power cord Top and front panels (See 1) 1 Cassette recorder keys: Back panel (See 1) 8 Telescopic antenna - improves FM/SW reception.
AQ4140_61 IFU 1/10/08 13:44 Page 5 Power Supply 1 2 3 4 • General Operation / Radio Using AC power General operation Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. Switching on and off and selecting functions If your set is equipped with a voltage selector, adjust the selector so that it matches with the local mains.
AQ4140_61 IFU 1/10/08 13:44 Page 6 Cassette Recorder General information on recording Cassette playback 1 Push the Source selector slider to TAPE 2 Press STOP•EJECT 9/ to open the cassette holder and insert a cassette and close the deck. 3 Press PLAY 1 to start playback. 4 To pause playback press PAUSE ;. To resume, press the key again. 5 By pressing F.FWD/REWIND 5 or 6, fast forwading/ rewinding of the tape is possible in both directions. To stop fast winding, press 9//.
AQ4140_61 IFU 1/10/08 13:44 Page 7 Maintenance & Safety Tape deck maintenance Safety information To ensure quality recording and playback of the tape deck, clean parts A, B and C as shown, once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean the deck. • Place the set on a flat, hard and stable surface so that the system does not tilt.
AQ4140_61 IFU 1/10/08 13:44 Page 8 Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
AQ4140_61 IFU 1/10/08 13:44 Page 9 9
AQ4140_61 IFU 1/10/08 13:44 Page 10 Meet Philips at the Internet http://www.philips.
