Always there to help you Register your product and get support at www.philips.
Contents 1 Important safety instruction 3 2 Your Bluetooth Speaker 4 4 5 3 Get started 6 6 7 7 4 Play from Bluetooth device 7 7 5 Play audio from an external device 8 6 Other features 8 8 9 9 What's in the box Overview of the main unit Connect power Set time Turn on Bluetooth reset Set alarm timer Set sleep timer Adjust display brightness 7 Product information Specifications 10 10 8 Troubleshooting 10 9 Notice 11 11 Disposal of your old product EN 2
1 Important safety instruction a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Warning •• Never remove the casing of this Bluetooth speaker. •• Never place this Bluetooth speaker on other electrical equipment. 2 Your Bluetooth Speaker •• Keep this Bluetooth speaker away from direct sunlight, naked flames or heat. •• To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. •• Ensure that you always have easy access to the power cord, plug or adapter to disconnect this Bluetooth speaker from the power.
Overview of the main unit e a b c f g d h i k j A U D IO IN l a SOURCE • Select a source.(Bluetooth/AUDIO IN) • Press repeatedly to switch to standby mode. b SLEEP • Set sleep timer. c SNOOZE/BRIGHTNESS • Snooze alarm. • Adjust display brightness. d Display panel • Show current information. g First Knob (HOUR) • Adjust hour. h Second Knob (MINUTE) • Adjust minute. i Third Knob (CLOCK/SET TIME/SET AL1/ SET AL2) • Set clock. • Set alarm.
3 Get started Option 2: Battery power Caution Always follow the instructions in this chapter in sequence. Connect power The unit can only be powered by supplied AC power. Batteries are only used for time and alarm backup if not connected with AC power. Option 1: AC power Warning •• Batteries contain chemical substances, so they should be disposed of properly. Note •• Batteries are not supplied with the accessories. •• bAt shows on the display when the battery level is low.
Set time 1 2 3 4 5 Rotate the Third Knob to "SET TIME" to activate clock setting mode. »» Hour and minute digits blinks. 4 Play from Bluetooth device Rotate the First Knob to adjust the hour. Rotate the Second Knob to adjust the minute. Press OK on the First Knob to confirm. »» The setting time is displayed. Rotate the Third Knob to CLOCK after setting. »» The hour and minute digits stops blinking. Turn on The clock radio turns on automatically once your plugged in.
5 Play audio from an external device Note 6 Other features Set alarm timer You can set two alarms to ring at different time. •• Make sure that the Third Knob switched to CLOCK before setting. Note •• The speaker can not pair with other Bluetooth devices in AUDIO IN mode. You can listen to audio from an external device through this Bluetooth speaker. 1 2 3 Connect an audio cable to: • the AUDIO IN socket on the Bluetooth speaker. • the headphone socket on an external device.
Activate/deactivate alarm timer Note •• Make sure that the Third Knob switched to CLOCK before setting. Press AL1/AL2 to activate or deactivate the alarm timer. »» The / appears if alarm timer is on and disappears if it is off. To stop the ringing alarm, press the corresponding AL1/AL2. »» The alarm repeats ringing for the next day. Snooze the alarm When alarm sounds, press SNOOZE. »» The alarm snoozes and repeats ringing nine minutes later.
7 Product information 8 Troubleshooting Warning •• Never remove the casing of this device. Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 5W RMS Bluetooth Bluetooth specification Supported profiles Range V3.0+EDR HFP v1.5, AD2P v1.2, HSP v1.
9 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Notice of compliance The device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: a This device may not cause harmful interference, and b This device must accept any interference received, including interference that may cause undesired operation.
Specifications are subject to change without notice 2014 © WOOX Innovations Limited. All rights reserved. This product was brought to the market by WOOX Innovations Limited or one of its affiliates, further referred to in this document as WOOX Innovations, and is the manufacturer of the product. P&F is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. AJT600D_37_UM_V2.
