Register your product and get support at www.philips.
1 2 3 4 5 Important 4 Your clock radio 4 Get started 7 Listen to FM/MW radio 9 Introduction What’s in the box Overview of the main unit Overview of the outdoor sensor Install battery Connect power Plug and set Select time zone Set clock Tune to radio stations Store radio stations automatically Store radio stations manually Select a preset radio station Adjust volume 4 4 5 6 7 7 8 8 8 9 9 9 9 9 Other features 10 Product informati
1 Important 2 Your clock radio • • • • Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. • • • • • • • • 4 Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
o a b n m l k c j d i e f h g a AL1/AL2 • Set alarm. • View alarm settings. • Activate/deactivate alarm timer. b Display panel • Show current information. c DST • Select daylight saving time (DST) mode. d TIME ZONE • Set time zone. e DISPLAY • Activate temperature display setting mode. f NATURE SOUND • Activate nature sound setting mode. g AC 6V ~ 450mA • Connect power.
h FM ANT • Improve FM reception. i TUNING MODE • Select tuning mode. j PRESET • Select a preset radio station. k FM/MW • Select tuner source. l SET TIME/PROG • Set time. • Program radio stations. Overview of the outdoor sensor a b c m SLEEP • Set sleep timer. n Main knob • Adjust volume. • Confirm selection. • Adjust settings. • Deactivate nature sound. g f o SNOOZE/BRIGHTNESS • Snooze alarm. • Adjust display brightness. e d a Display panel • Show outdoor temperature and RF channel.
Always follow the instructions in this chapter in sequence. Install battery Replace battery of the main unit English 3 Get started Note •• You can only use AC power as power supply. The pre- installed lithium CR2032 battery can only back up clock and alarm settings. When the low battery icon is displayed, replace the battery as indicated. Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.
Set clock If the preset time is inaccurate, you can set time and date manually. 1 2 3 4 Plug and set Time has been preset at the factory. When power is connected, the set time is displayed automatically. The built-in lithium battery can maintain clock setting despite power interruption. Select time zone You can adjust time zone setting according to your location. 1 2 3 In standby mode, press TIME ZONE. »» The current time zone number blinks on the display.
Tune to radio stations Tip •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For better reception, fully extend and adjust the position of the antenna. 1 2 3 4 5 2 1 2 3 4 5 Tune to a radio station. Press PROG. »» The preset number begins to blink. Rotate the main knob to select a number. Press the knob to confirm. »» [DONE] (done) is displayed. Repeat steps 1 to 4 to store other stations.
5 Other features Display indoor/outdoor temperature 2 3 4 Adjust temperature display 1 2 3 Press DISPLAY. Rotate the knob to select a temperature display mode for the main unit: • Display indoor temperature; • Display outdoor temperature detected from channel 1/2/3; or • Display indoor and outdoor temperature alternatively. Press the knob to confirm. Rotate the knob until the corresponding icon appears. Press the knob to confirm. Switch the CHANNEL control to 2 or 3.
4 5 6 Press the main knob to confirm. »» The minute digits and [AL1]/[AL2] begin to blink. 30 60 90 120 OFF Repeat Step 2-3 to set minute. Repeat Step 2-3 to select whether to ring alarm for the whole week, on weekdays (Monday to Friday), or on the weekend (Saturday and Sunday). Repeat steps 2-3 to select an alarm source: radio, buzzer, or a nature sound. Activate/deactivate alarm timer 1 2 15 English 3 Press AL1/AL2 to view alarm settings.
6 Product information Note •• Product information is subject to change without prior notice. Amplifier 0.6 W RMS Tuner Tuning Range Sensitivity - Mono, 26dB S/N Ratio FM: 87.
8 Notice English 7 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ7010_12_CCR_V1.
