Register your product and get support at EN User manual AJ7010
A o a b n m c d e f l k j i h g
B a b c g f e d
C D
E F
EN 1 • • • • • • • • • • • • Important Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM/MW radio; • set two alarms; • view time, date, and indoor/outdoor temperature; • adjust time zone and daylight saving time; and • be waken up by buzzer, radio, or stored nature sounds.
b c d e f g h i j k l m Display panel Show current information. • DST • Select daylight saving time (DST) mode. TIME ZONE • Set time zone. DISPLAY Activate temperature display setting mode. • NATURE SOUND • Activate nature sound setting mode. AC 6V ~ 450mA Connect power. • FM ANT Improve FM reception. • TUNING MODE Select tuning mode. • PRESET Select a preset radio station. • FM/MW Select tuner source. • SET TIME/PROG Set time. Program radio stations. • • SLEEP Set sleep timer.
n o Main knob Adjust volume. Confirm selection. Adjust settings. Deactivate nature sound. • • • • SNOOZE/BRIGHTNESS Snooze alarm. Adjust display brightness. • • Overview of the outdoor sensor B a b c d e f g Display panel Show outdoor temperature and RF channel. • LED light Blink when transmitting data to the main unit. • Sensor support °C/°F slide Switch between Centigrade (°C) or Fahrenheit (°F) temperature display. • CHANNEL1/2/3 Select RF channel to transmit signals.
3 Get started Always follow the instructions in this chapter in sequence. Install battery Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. •• The battery contains chemical substances, so it should be disposed of properly. •• Keep children away from the battery.
Replace battery of the main unit D Note •• You can only use AC power as power supply. The pre-installed CR2032 battery can only back up clock and alarm settings. When the low battery icon is displayed, replace the battery as indicated. Connect power E Caution •• Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. •• Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket.
Select time zone You can adjust time zone setting according to your location. 1 2 3 In standby mode, press TIME ZONE. »» The current time zone number blinks on the display. Rotate the main knob to set time zone (-1 to +12 adjustable). Press the knob to confirm. For Europe: Western European Time (WET) +0 Central European Time (CET) +1 (Default) Eastern European Time (EET) +2 Moscow Standard Time (MST) +3 Set clock If the preset time is inaccurate, you can set time and date manually.
Tip •• In time and date setting mode, if you press and hold the knob for 3 seconds, the clock radio will save the change and quit the setting mode. 4 Listen to FM/MW radio Tune to radio stations Tip •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For better reception, fully extend and adjust the position of the antenna. 1 2 3 4 5 Press FM/MW to select FM or MW tuner source. Press TUNING MODE repeatedly until [FIND] (find) blinks. Rotate the main knob slowly.
2 Rotate the knob slowly to select a frequency. Store radio stations automatically You can store a maximum of 20 FM radio stations and 10 MW radio stations. 1 2 In tuner mode, press TUNING MODE repeatedly until [AUTO] (auto) blinks. Rotate the main knob slowly. »» The clock radio stores all the available FM/MW radio stations and broadcasts the first available station automatically. Store radio stations manually 1 2 3 4 5 Tune to a radio station. Press PROG. »» The preset number begins to blink.
Select a preset radio station In tuner mode, press PRESET, then rotate the main knob to select a preset number. Adjust volume F 5 Other features Display indoor/outdoor temperature Adjust temperature display 1 2 3 Press DISPLAY. Rotate the knob to select a temperature display mode for the main unit: • Display indoor temperature; • Display outdoor temperature detected from channel 1/2/3; or • Display indoor and outdoor temperature alternatively. Press the knob to confirm.
Tip •• To convert between Centigrade (°C) and Fahrenheit (°F) temperature display, adjust °C/°F slide inside the battery compartment of the sensor. •• If the main unit fails to receive signal from the sensor, only indoor temperature can be displayed. Improve sensor reception When battery is correctly installed in the sensor, the sensor starts to transmit RF signal to the main unit through Channel 1/2/3.
1 2 3 4 Press NATURE SOUND. Rotate the knob to select a nature sound. Press the knob to confirm. Rotate the knob to adjust the volume level of the nature sound (0-8). Tip •• To deactivate the nature sound, press the knob again. Set alarm timer Set alarm You can set two alarms to ring at different time. Note •• Make sure that the clock is set correctly. 1 2 3 4 In standby mode, press and hold AL1/AL2 for two seconds to activate alarm setting mode. »» The hour digits and [AL1]/[AL2] begin to blink.
5 6 7 Repeat Step 2-3 to select whether to ring alarm for the whole week, on weekdays (Monday to Friday), or on the weekend (Saturday and Sunday). Repeat steps 2-3 to select an alarm source: radio, buzzer, or a nature sound. Repeat steps 2-3 to set the alarm volume. Activate/deactivate alarm timer 1 2 Press AL1/AL2 to view alarm settings. Press AL1/AL2 again to activate or deactivate the alarm timer. »» [AL1]/[AL2] appears if alarm timer is on and disappears if it is off.
To deactivate the sleep timer: In sleep timer setting mode, rotate the knob until [OFF] (off) appears, then press the knob. 15 30 60 90 120 OFF Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold DST for 3 seconds. »» The clock advances by one hour and [DST] is displayed.
Specifications Amplifier Rated Output Power 0.6 W RMS Tuner Tuning Range FM: 87.
Dimensions - Main Unit (W x H x D) 197 x 80 x 45 mm Weight - With Packing - Main Unit 0.9 kg 0.5 kg 7 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support).
No signal detected from the sensor •• Check if the battery is correctly installed in the sensor. •• Reduce the distance between the main unit and the sensor. •• Press RESET on the sensor to restart transmission. •• Change to another channel to transmit signal. 8 Notice This product complies with the radio interference requirements of the European Community.
Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste.
Norge Typeskilt finnes på apparatens underside. Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten. For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. AJ7010_12_UM_V2.
