Register your product and get support at www.philips.
A B AL S ET CK CLO 1 SE T A L 2 SE T T I ME MI N PR ESE T TUNING HR SC G SL O EE P AN PR 1 OJ E AL 2 AL PR C T IO N R AD IO SNOOZE B R I G H T N E S S a b c de f g h ij k
12/24H TIME ZONE AL 2 AL 1 FLIP 18 0° 0° DST p o n l m B RADIO BUZZ 1 RADIO BUZZ 2 VOL C s r D 12/24 H TIME ZONE DST CLOCK RADIO AJ 5030 FLIP 0° VOL 18 0° AL 1 RADIO BUZZ AL 2 1 RADIO BUZZ 2 q
b AL 1 SE T A L 2 SET SE T T I HR ME AL 1 SE T A L 2 SET SE T T I O CK CL ME HR T U NI N G SC SC SL G 1 PR OJ EC TI O N 1 AL 2 AL AL 2 G SL O O EE P EE P PR PR N R AD N A A PR OJ EC TI O N AL HR T U NI N G P RESE T O CK CL P RESE T SET TIME IO R AD S NO OZE S NO OZE B R I GH T N ES S B R I GH T N ES S IO d C LO C K MIN AL 1 SE T A L 2 SET SE T T I ME P RESE T HR M IN O CK CL T U NI N G O G SL PR N O EE P A PR N EE P A SC SC G IO 2 PR O
a b SET AL 1 HR IM E AL SET CK CL O 1 SE T A L 2 SET T IM E HR TUNI N G SC P LE E S S OG OG LE E P PR AL 1 PR 1 2 AL AL OJ E C TIO N 2 PR AN AN SC PR O R AD I OJ E C TIO N AL HR TU NI N G M IN 1 SE T A L 2 SET T P R E SE T AL SET CK CL O P R E SE T SET AL 2 M IN O R AD I SN OO ZE SN OO ZE B R I GH T N E S S B R I GH T N E S S c d C LO C K MI N IM E 1 SE T A L 2 SET T IM E P AL O R AD I S AL 1 OG 2 PR AN AL OJ E C TIO N LE E S SC OG LE E
EN 1 Important Safety • • • • • • • • • • • Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.
• Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can: •• listen to FM radio; •• know the time; •• wake up by buzzer alarm, radio, or melody; and •• view time projected on a wall or ceiling.
• d e f g h i j k l m View alarm settings. PROG/SCAN Scan/store radio stations. • PROJECTION Turn on/off projector. • BRIGHTNESS/SNOOZE Snooze alarm. Adjust display brightness. • • RADIO Turn on/off radio stations. turn off the ringing alarm. • • SLEEP Set sleep timer. • MIN/PRESET +/Adjust minute. Select a preset radio station. • • CLOCK/SET AL1/SET AL2/SET TIME Set time/alarm. View time. • • Projector Project time onto wall/ceiling. Adjust projected direction.
n o p FLIP 0°/180°: reverse projected image. • AL1/RADIO·BUZZ· 1 Select alarm source for Alarm 1. • AL2/RADIO·BUZZ· 2 Select alarm source for Alarm 2. • q Power cord & Antenna r Battery tray s 3 VOL Adjust volume. • Get started Always follow the instructions in this chapter in sequence. Install battery C Warning •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Danger of explosion if battery is incorrectly replaced.
Note •• You can only use AC power as power supply. The lithium CR2032 battery is only for back-up purpose. •• When power is disconnected, the display backlight is off. When is displayed, you need replace the battery as indicated. Connect power D Caution •• Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. •• Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket.
For Europe: Western European Time (WET) +0 Central European Time (CET) +1 (Default) Eastern European Time (EET) +2 Moscow Standard Time (MST) +3 Set clock E In standby mode, you can set clock manually. Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold 12/24H·DST for two seconds. »» The clock advances by one hour. Tip •• To exit DST mode, repeat the above operation.
Note •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For optimal reception, fully extend and adjust the position of the antenna. Note •• To turn on/off radio, press RADIO. Store FM radio stations automatically You can store up to 20 FM radio stations. 1 Press RADIO to turn on the radio. 2 Press and hold PROG for two seconds. »» The clock radio stores all the available FM radio stations and broadcasts the first available station automatically.
Note •• To remove a pre-stored station, store another station in its place. Select a preset radio station In tuner mode, press PRESET +/- to select a preset number. Adjust volume G 5 Set alarm timer Set alarm time H In standby mode, you can set two alarms to ring at different time. Select alarm sound For the alarm sound, you can select buzzer, your last heard radio, or the melody stored in the clock radio. Adjust AL1/RADIO·BUZZ· 1 or AL2/RADIO·BUZZ· 2 to select alarm sound for Alarm 1/Alarm 2.
• • To stop alarm, press the corresponding AL1/AL2 (or RADIO). The alarm repeats ringing for the next day. Note •• When alarm sounds, you cannot adjust volume by rotating VOL. Snooze alarm When alarm sounds, press SNOOZE. »» The alarm snoozes and repeats ringing five minutes later. To adjust alarm interval (in minutes), press SNOOZE repeatedly. 5 10 15 6 20 25 30 Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period.
Project time onto wall/ceiling J By projecting time onto a wall or ceiling, this clock radio offers you a unique way to read time in the dark. Warning •• Risk of damage to eyes! Do not look at the glowing red light constantly. Note •• Before you start, switch CLOCK/SET AL1/SET AL2/SET TIME to CLOCK. 1 2 3 4 Press PROJECTION to turn on the projector. Rotate the projector to adjust the projected direction. Rotate the focus ring to adjust the image sharpness.
7 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 0.6W RMS Tuner Tuning Range FM: 87.
Standby Power Consumption <1W Dimensions - Main Unit (W x H x D) 136 x 66x 136 mm Weight - With Packing - Main Unit 0.6 kg 0.4 kg 8 Troubleshooting Warning •• Never remove the casing of this clock radio. To keep the warranty valid, never try to repair the clock radio yourself. If you encounter problems when using this clock radio, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support).
9 Notice This product complies with the radio interference requirements of the European Community. Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to operate the equipment. Note •• The type plate is located on the bottom of the apparatus. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
old product helps to prevent potential negative consequences for the environment and human health. Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted.
15 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. AJ5030_12_UM_V5.
