CONTROLS INSTALLATION { usslfi"ij |TOP, FRONT and SIDE PANEL ’ ?%r VOLUME: To adjust the radio sound level T T i TUNING /1ea 0r wet {up o7 down} (D REPEAT Alliterative DATE: « To tune to radii stations automatically o ~ To switch off the alarm for a @ minute manually ! ' period.
INSTALLATION SETTING DATA AUTOMATICALLY Power breakdown In the event of a power failure the set will be completely switched off. Disconnect the set first and re-plug after 3 seconds or more. All settings will remain in the memory, but you will need to reset the clock time, date and year. For /00 and /05 versions, you may Eave the set to reset automatically by radio controlled clock signal. For users in the UK.
SETTING DATA MANUALLY | SETTING THE TIME, DATE AND YEAR MANUALLY General The tads for the clock time, date and year need ta be entered separately. Setting the time manually 1. If necessary, press the REPEAT ALARM/TIME DATE button anti the display shows the time mode. — If the time display 00:00 is already flashing, go to step 3. 2. Press SET to activate the setting mode. The time display will start flashing. 3. Use TUNING / vea 0r > to adjust the hours and minutes.
SETTING DATA MANUALLY | TIME ZONE SETTING This feature allows you to set the clock display with up to Z hours difference from the radii controlled clock time. 1. Press the WEEKEND SLEEPER/TIME 20NE button once. — 1f the display shows the time zen setting £15:55, no time difference has been selected. 2, Press TUNING briefly to select up to 2 hours difference. 3. Press the WEEKEND SLEEPER/ME Zone button twice if you wash to exit the time one display immediately.
RADIO ALARM l ysiibuy i Tuning TO A STATION MANUAL tuning This is useful if you know the radio frequency of the station. 1. Crass the TUNING /e« or 24 control briefly unit you find the desired station. AUTOMATIC tuning 7. Neap TUNING /e 0r »91 pressed until the display frequency starts to run and then release. ~ The display will show Arch. 2. When a station has been fauns, tuning will spat, or you can stop the automatic tuning by pressing the TUNING aconite again.
ALARM 2. Use TUNING the alarm time; w With TUNING /1< o7 »»s pressed, the display will increase or decreases the alarm time rapidly and continuously from minutes 10 hours. — Tress TUNING /e« or w briefly and repeatedly to adjust the alarm teems minute by minute. 3.
ALARM on / off | stinkbug [SWITCHING OFF THE ALARM Hers are two ways to switch off the alarm. Unless you cancer the alarm completely, the ALARM RESET will he automatically defected after 80 minutes, from the time your alarm first sounds. Note: During an alarm call or repeat alarm, only the ALARM RESERVATION OFF and REPEAT ALARM/TIME pave controls on the set will operate. Alarm reset If you want the alarm mode to be stopped Immediately but lase wish to retain the same lama setting for the following day: 1.
SLUMBERING MAINTENANCE [SLUMBER | English 1 | Shout slumber time The clack radio has a built device called the slumber, which enables the set to be automatically switched off during radio playback after a set period of time, There are three slumber mes: minutes before the set tums itself off. You can set the stumbler time when the radio is either an or off. DIGITAL CLOT RAID Setting the slumber 1. Press the RADIO ON button.
TROUBLESHOOTING | l | ladybug fault scours, first check the points sifted below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center, WARNING: under no circumstances should you try to repair the set yourself, as this would invalidate the guarantees.
