CONTROLS INSTALLATION ysigéug TOF, FRONT and SIDE PANEL (1) REPEAT ALARM/TIME DATE: ~ T switch off the alarm for @ 8 minute period, ~ To display/adjust the date {month and day} and the year ~ To resume clock time display (2 DISPLAY: To show the status of the set (3 PRESET 1-5: — To select & preset radio station — To select a preset radio alarm (& ALARM HORSETRADING OFF: ~ To stop the active alarm for 24 hours — Yo switch off alarm 1 or 2 completely — To switch off the roadie (& SLUMBER/BUZZER To adjust the
INSTALLATION Power breakdown In the Levant of a power failure the set will be completely switched off. Disconnect the set first and re-plug after 3 seconds or more. Most of the settings will remain in the memory, but you will need to reset the clock time, date and year. For users in the ULK: gasses follow the instructions on page 2 Connecting headphones / loudspeakers Connect headphones / loudspeakers with a 3.5 mm fag into the 2 socket. ~ The built-in loudspeaker will now be muted.
SETTING DATA ysyfiug INSETTING THE TIME, DATE AND YEAR General The data for the clock time, date and year need to be entered separately. Setting the time 1, 1f necessary, press the REPEAT MALLARME DATE button until the display shows the time mode. ~ 1f the time display 00:00 is already flashing, go to step 3. 2. Press SET to activate the setting mode, — The time display will start flashing. 3, Use TUNING adjust the hours and minutes.
SETTING DATA TIME ZONE SETTING This feature allows you to set the clock display with up to 2 hours difference from normal focal time. The TIME ZONE setting can he useful when you want to change 1o or from summer time if there is a seasonal time difference. However, make sure the time zone is set at 00:00 if there is no time difference. 1. Press the WEEKEND SLEEPER/TIME ZONE button ounce. =1 the display shows the time zone setting 5858, no time difference has been selected, 2.
RADIO ALARM syringing [TUNING TO A STATION MANUAL tuning This is useful if you know the radio frequency of the station. 7. Press the TUNING /see or »m control briefly unit) vou find the desired station. AUTOMATIC tuning 1. Keep TUNING /e o w3 pressed until the display frequency starts to run and then release. ~ The display will show Arch. 2. When a station has been found, tuning will step, or you can stop the automatic tuning by pressing the TUNING /e or s control again.
ALARM Z. U Use TUNING /ra« or »» o set the slam: time; = With TUNING 7 ree or »»1 pressed, the display will increase or decrease the alarm time rapidly and continuously from minutes to hours. — Press TUNING /e« or wet briefly and repeatedly to adjust the lama time minute by minute, 3.
ALARM on / off [SWITCHING OFF THE ALARM ‘There are two ways to switch off the alarm, Unless you cancer the alarm completely, the ALARM RESET will be automatically selected after 66 minutes, from the time your alarm first sounds, Note: During an alarm call o repeat alarm, only the ALARM RESET/RADIO OFF and REPEAT ALARM/TIME DATE controls on the set will operate. fuzzy Alarm reset 1f you want the alarm mode to be stopped immediately but lase wish to retain the same alarm setting for the following day: 1.
SLUMBERING MAINTENANCE [s Lumber About slumber time The clock radio has a built-in device called the slumber, which enables the set to be automatically switched off during radio playback after g set period of time. There are three slumber times: minutes before the set tums itself off. You can set the clamber time whee the radio is either on or off. biomass, 606K RADII d Setting the slumber ARG SR 1. Select your slumber time by pressing the Slumberous O O Nee or more; export | e | SILO one.
TROUBLESHOOTING stinkbug I a fault occurs, first sack the points listed below before taking the set for repair. £ you are unable to remedy a problem by following these hints, consult your dealer or service center. 'WARNING: dater no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.
AJ 3720 CLOCK RADIO Meet Philips at the Internet % 3140 115 24421 Printed in Hong Kong TC text/AW/G723
