Clock Radio User manual AJ 3600
3 E PR OJ EC TIO PRO N JE CT IO N O 3 N RE FF VE RS /O 2 1 T + UR HO AL AR M ON SE 1 PRESET 1- 5 1 TA 2 LA RM 3 5 4 SET T I ME 6 TE + 8 T 4 C MINU 9 SE PR OJE 2 5 TE TI RO A 7
1 1 RADIO ON/OFF 2 BAND 3 ALARM RESET/SLEEP 5 REPEAT ALARM BRIGHTNESS CONTROL AL 4 AL ON OFF PRESET 1 AJ3600 PROJECTION CLOCK RADIO AL1 9 2 1 TUNING 2 VOLUME DC 7.
5 RADIO FM AL AL AL AL ON ON ON OFF PRESET 5 6 E PR OJ EC TIO Max.
English SUPPLIED ACCESSORIES – 1 X certified AC 7.
LEFT & RIGHT PANEL (See 3) 1 2 3 4 5 6 7 8 9 Projection lens REVERSE PROJECTION – turns time/hour digits upside down(AC-powered only) PROJECTION ON/OFF – switches the projection on/off ROTATE PROJECTION – adjusts projection slightly to a different angle SET ALARM 1 / PRESET 1 – sets ALARM 1 time – stores, recalls and shows station 1 SET ALARM 2 / PRESET 2 – sets ALARM 2 time – stores, recalls and shows station 2 MINUTE + / PRESET 3 – adjusts the minutes for clock and alarm times – stores, recalls and shows
• Make sure your adapter is properly connected to save battery energy! 2 Always disconnect the mains adapter if you are not using the set. ™ indicator goes out. Helpful hints: To avoid damage to the set, use only the adapter supplied! The type plate is located on the bottom of the set inside the battery compartment. SELF-POWERED BACK-UP The self-powered back-up conveniently allows your preset stations, alarm and clock time settings to be stored for up to 3 minutes when there is a power interruption e.g.
Helpful hints: – When battery-powered, the display illumination is default low to help save energy. Any other use of the BRIGHTNESS CONTROL for a brighter display adjustment will therefore be effectively limited. SETTING THE CLOCK The time is displayed using the 24-hour clock. 1. Check the radio is switched off. 2. Press SET TIME to enter the clock setting mode. 3. Hold down or press HOUR + or MINUTE + repeatedly to set and adjust the hours and minutes respectively.
To improve reception: For FM, extend and position the pigtail fully to obtain optimum reception. For MW, the set is provided with a built-in aerial. Direct the aerial by adjusting the position of your clock radio. STORING AND USING PRESET STATIONS You can store up to a total of 10 radio stations in the memory, 5 on each waveband. 1 Tune to your desired station (see TUNING TO RADIO STATIONS). 2 To store a preset, hold down briefly on a PRESET button 1-5 until you hear a double beep.
Helpful hints: – If you have selected AL 1 (AL ), make sure you have properly tuned to a station before turning off the set. – If you set and activate the same time for both alarms, only the AL 2 (AL ) will be activate at the set time. – When both AL 1 (AL ) and AL 2 (AL ) are turned on, by default the display shows the alarm time nearest to activation. – To check the alarm time setting for AL 1 or AL 2, press AL 1 or AL 2 button.
SLEEP (See 6) About Sleep This set has a built-in sleep timer, which enables the radio to be automatically switched off after a set period of time. There are four sleep time options. Setting and switching off SLEEP 1 Within 1 second, press ALARM RESET / SLEEP twice until the display shows SLEEP and SL: 60. ™ The radio is automatically switched on and tunes to the last station. 2 To select other sleep time options, press ALARM RESET / SLEEP again within 1 second before the display returns to clock time.
SAFETY & MAINTENANCE INFORMATION • Install the unit near the AC outlet and where the AC power plug can be easily reached. • The apparatus shall not be exposed to dripping or splashing. • If you do not intend to use set for a long time, remove the batteries. • Do not expose the set to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • To clean your set, use a soft damp cloth or chamois leather. Do not use cleaning products, which contain benzene, thinner, etc.
Display error / no reaction to any controls – Electrostatic discharge • Press the RESET hole on the bottom of the set with a ball-pen. Or disconnect set from AC/DC adaptor and batteries for 5 minutes, then re-plug. Continuous crackling and hiss noise during MW reception – Interference from other electrical equipment e.g.
AUSTRALIA - Philips Manufacturers Warranty for Australia only These warranty conditions are valid for the following consumer electronics products: Colour Televisions, Projection TV, Plasma & LCD TV, Video Cassette Recorders, CD Recorders & Players, DVD Players, DVD Recorders, DVD Recorders with HDD, Audio Systems, Home Theatre systems, Digital Set Top Box & Portable Audio products.
NEW ZEALAND - Guarantee and Service for New Zealand Thank-you for purchasing this quality Philips product. Philips New Zealand Ltd guarantees this product against defective components and faulty workmanship for a period of 12 months. Any defect in materials or workmanship occurring within 12 months from the date of purchase subject to the following conditions will be rectified free of charge by the retailer from whom this product was purchased. Conditions 1.
Clock radio Meet Philips at the Internet http://www.philips.
