Register your product and get support at www.philips.
1 a b d c e j f k g l m n h i Norge Typeskilt finnes på apparatens underside. Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten. For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.
EN 1 Important Safety Important Safety Instructions a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. l Unplug this apparatus during lightning storms or when unused for long periods of time. m Refer all servicing to qualified service personnel.
Warning • • • • • Never remove the casing of this apparatus. Never lubricate any part of this apparatus. Never place this apparatus on other electrical equipment. Keep this apparatus away from direct sunlight, naked flames or heat. Ensure that you always have easy access to the power cord, plug or adaptor to disconnect the apparatus from the power. Notice This product complies with the radio interference requirements of the European Community.
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed of with normal household waste. Please inform yourself about the local rules on separate collection of batteries. The correct disposal of batteries helps prevent potentially negative consequences on the environment and human health. Environmental information All unnecessary packaging has been omitted.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can: • listen to the radio • know the time • set alarm timer to wake you up at certain time. What’s in the box Check and identify the contents of your package: • Main unit • User manual Overview of the main unit (See 1) a SET ALARM/CLOCK/SET TIME • • Set the alarm timer/time.
e REPEAT ALARM/BRIGHTNESS CONTROL • • Repeat the alarm. Adjust the display brightness. f AUTOSCAN • Program radio stations. g SLEEP/ALARM RESET • • Set the sleep timer. Reset the alarm timer. h BUZZER/RADIO ALARM • Set the alarm mode. i MW/FM • Select a waveband. j - PRESET + • Select a preset radio station. k ALARM ON/OFF • Turn on/off the alarm timer. l RADIO ON/OFF • Turn on/off the radio. m TUNING +/- • Tune to a radio station. n VOL +/- • Adjust volume.
3 Get started Caution • Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
Connect power Caution • Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the apparatus. • Risk of electric shock! When you unplug the AC adaptor, always pull the plug from the socket. Never pull the cord. • Before connecting the AC adaptor, ensure you have completed all other connections. Note • The type plate is located on the bottom of the main unit. 1 Plug the AC power cord to the wall socket.
Set clock 1 2 3 4 In standby mode, rotate SET ALARM/CLOCK/SET TIME to the SET TIME position. » The hour and minute digits begin to blink. Rotate HOUR to set the hour. Rotate MINUTE to set the minute. Rotate the SET ALARM/CLOCK/SET TIME to the CLOCK position to confirm. Adjust volume level 1 During play, turn VOL +/- to increase/decrease the volume level.
4 Listen to radio Tune to a radio station Tip • Position the antenna as far as possible from TV, VCR or other radiation source. • For optimal reception, fully extend and adjust the position of the antenna. 1 2 3 4 • Press RADIO ON/OFF to turn on the radio. Adjust MW/FM to select MW or FM tuner. Press and hold TUNING +/- for more than 2 seconds. » The radio tunes to a station with strong reception automatically. Repeat step 3 to tune to more stations.
2 3 4 5 Press AUTOSCAN to activate the program mode. » The preset number begins to blink. Press PRESET +/- to select a number. Press AUTOSCAN to confirm. Repeat the above steps to program other stations. Note • To overwrite a programmed station, store another station in its place. Select a preset radio station 1 Press - PRESET + to select a preset number.
5 Other features Set the alarm timer 1 2 3 4 5 Ensure that you have set the clock correctly. In standby mode, rotate SET ALARM/CLOCK/SET TIME to the SET ALARM position. » The hour and minute digits begin to blink. Rotate HOUR to set the hour. Rotate MINUTE to set the minute. Rotate the SET ALARM/CLOCK/SET TIME to the CLOCK position to confirm. Set alarm mode 1 Adjust the BUZZER/RADIO ALARM control to select the source for the alarm.
Activate and deactivate the alarm timer 1 Press ALARM ON/OFF repeatedly to activate or deactivate the alarm timer. Repeat alarm 1 When the alarm rings, press REPEAT ALARM/BRIGHTNESS CONTROL. » The alarm repeats ringing minutes later. Tip • You can press TUNING+/- to adjust interval to repeat alarm. Stop alarm sound 1 When the alarm rings, press SLEEP/ALARM RESET. » The alarm stops but the alarm settings remain.
1 Press SLEEP repeatedly until [OFF] (off) is displayed. disappears on the » When the sleep timer is deactivated, display. Adjust display brightness 1 Press REPEAT ALARM/BRIGHTNESS CONTROL repeatedly to select different levels of display brightness.
6 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 0.
Tuner Tuning Range FM: 87.5 - 108 MHz MW: 531-1602 KHz Tuning grid FM: 50 KHz MW: 9KHz Sensitivity FM: <22 dBu - Mono, 26dB S/N Ratio MW: <92 uV/m Search Selectivity FM: <28 dBu MW:<98 uV/m Total Harmonic Distortion FM: <3% MW:<5% Signal to Noise Ratio FM: >45 dB MW:>40 dB General information AC power 220 ~240 V, 50/60Hz Operation Power Consumption <5W Standby Power Consumption <2W Dimensions 172 x 92 x 72 mm Weight 0.
7 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
© Royal Philips Electronics N.V. 2009 All rights reserved. Specifications are subject to change without notice.Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners.
