Register your product and get support at EN User manual AJ3270D
A e f g h i a b c j d k l m n
B C
D E
F G VOL +/-
H a b RADIO a b RADIO TUNING +/HR HR I PM FM
EN 1 Important Safety • • • • • • • • • • • Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.
• 2 Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM radio; • enjoy audio from iPod/iPhone; • know the time; and • wake up by buzzer alarm, radio, or audio in iPod/iPhone.
c MIN/PRESET +/• Set minute. • Select a preset radio station. d Display panel • Show current information. e SLEEP • Set sleep timer. f SCAN/PROG/SET TIME • Scan/store radio stations. • Set time. g VOL +/• Adjust volume. h RADIO • Turn on/off radio. i AL1/AL2 • Set alarm. • Turn on/off alarm. • View alarm settings. j BRIGHTNESS/SNOOZE • Snooze alarm. • Adjust display brightness. k DOCK for iPhone/iPod l FM ANT • FM antenna. m DC IN 5V/2A • Power supply socket.
3 Get started Always follow the instructions in this chapter in sequence. Install battery Warning •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. •• The battery contains chemical substances, so it should be disposed of properly. •• Keep children away from the battery. Note •• You can only use AC power as power supply.
Connect power D Caution •• Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. •• Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket. Never pull the cord. Set clock 1 2 3 4 5 In standby mode, press and hold SET TIME for two seconds. »» The current time is displayed. »» The hour and minute digits begin to blink. Press HR+/- and MIN+/- repeatedly to set hour and minute.
4 Play from iPhone/iPod You can enjoy audio from iPhone/iPod through this clock radio. Compatible iPhone/iPod The clock radio supports these iPod and iPhone models: Made for. • iPod touch (1st, 2nd, 3rd, and 4th generation) • iPod classic • iPod with video • iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th generation) • iPod with color display • iPod mini • iPhone 4 • iPhone 3GS • iPhone 3G • iPhone Listen to audio from iPhone/iPod E 1 2 3 Place the iPhone/iPod in the dock.
Remove the iPhone/iPod F Pull the iPhone/iPod out of the dock. Charge the iPhone/iPod When the clock radio is connected to power, the docked iPhone/iPod starts charging. Adjust volume G 5 Listen to FM radio Tune to FM radio stations H Tip •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For better reception, fully extend and adjust the position of the antenna. Note •• To turn on/off radio, press RADIO.
Store FM radio stations automatically You can store a maximum of 20 FM radio stations. 1 Press RADIO to turn on the radio. 2 Press and hold PROG for two seconds. »» The clock radio stores all the available FM radio stations and broadcasts the first available station automatically. Store FM radio stations manually 1 2 3 4 5 Tune to an FM radio station. Press PROG. »» The preset number begins to blink. Press PRESET +/- or TUNING +/- repeatedly to select a number. Press PROG again to confirm.
6 Other features Set alarm timer Set alarm time I You can set two alarms to ring at different time. Note •• Make sure that you have set the clock correctly. 1 2 3 Press and hold AL1/AL2 for 2 seconds to enter alarm setting mode. »» The hour and minute digits begin to blink. »» or is displayed accordingly. Press HR+/- and MIN+/- repeatedly to set hour and minute. Press AL1/AL2 again to confirm.
Tip •• When alarm time arrives and you are listening to radio or audio in iPhone/iPod, buzzer can only be activated as alarm sound. •• If you have selected iPhone/iPod source, while no iPhone/iPod is connected, the clock radio switches to buzzer source instead. Activate/deactivate alarm timer 1 2 Press AL1/AL2 to view alarm settings. Press AL1/AL2 again to activate or deactivate the alarm timer. »» or appears if alarm timer is on and disappears if it is off.
»» When the sleep timer is activated, appears. To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off) appears. 15 30 60 90 120 off Adjust display brightness Press BRIGHTNESS repeatedly to select different brightness levels: high, mid, and low. 7 Product information Note •• Product information is subject to change without prior notice.
Tuner Tuning Range FM: 87.5 - 108 MHz Tuning grid FM: 50 KHz Sensitivity - Mono, 26dB S/N Ratio FM: <22 dBu Search Selectivity FM: <28 dBu Total Harmonic Distortion FM: <3% Signal to Noise Ratio FM: >45 dB General information AC Power Model: AS100-050-AB200; Input: 100-240 V ~, 50/60Hz, 0.5A;Output: 5 V , 2.0A Operation Power Consumption <10 W Standby Power Consumption <2 W Dimensions - Main Unit (W x H x D) 130 x 66 x 145.8 mm Weight - With Packing - Main Unit 0.6 kg 0.
8 Troubleshooting Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
“Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod or iPhone respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. iPod and iPhone are trademarks of Apple Inc., registered in the U.S.
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted.
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ3270D_93_UM_V1.
