Register your product and get support at EN User manual AJ3270D
A e f g h i j a b c d k l m n
B C
D E
F G VOL +/-
H a RADIO b TUNING +/HR HR I PM FM
EN 1 Important Safety • • • • • • • • • • • Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• 2 Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • listen to FM radio; • enjoy audio from iPod/iPhone; • know the time; and • wake up by buzzer alarm, radio, or audio in iPod/iPhone.
• Tune to radio stations. c MIN/PRESET +/• Set minute. • Select a preset radio station. d Display panel • Show current information. e SLEEP • Set sleep timer. f SCAN /PROG/SET TIME • Scan/store radio stations. • Set time. g VOL +/• Adjust volume. h RADIO • Turn on/off radio. i AL1/AL2 • Set alarm. • Turn on/off alarm. • View alarm settings. j REPEAT ALARM/BRIGHTNESS CONTROL • Snooze alarm. • Adjust display brightness. k DOCK for iPhone/iPod l FM ANT • FM antenna. m DC IN 5V/2A • Power supply socket.
• 3 Select alarm source. Get started Always follow the instructions in this chapter in sequence. Install battery Warning • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fi re. • Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. • The battery contains chemical substances, so it should be disposed of properly. • Keep children away from the battery. Note • You can only use AC power as power supply.
Connect power D Caution • Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. • Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket. Never pull the cord. Set clock 1 In standby mode, press and hold SET TIME for two seconds. » The current time is displayed. » The hour and minute digits begin to blink. 2 3 Press HR+/- and MIN+/- repeatedly to set hour and minute.
Compatible iPhone/iPod The clock radio supports these iPod and iPhone models: Made for. • iPod touch (1st, 2nd, 3rd, and 4th generation) • iPod classic • iPod with video • iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th generation) • iPod with color display • iPod mini • iPhone 4 • iPhone 3GS • iPhone 3G • iPhone Listen to audio from iPhone/iPod E 1 2 3 Place the iPhone/iPod in the dock. Press iPhone to enter iPhone/iPod mode. Play audio from the iPhone/iPod.
Charge the iPhone/iPod When the clock radio is connected to power, the docked iPhone/iPod starts charging. Adjust volume G 5 Listen to FM radio Tune to FM radio stations H Tip • Position the antenna as far as possible from TV, VCR, or other radiation source. • For better reception, fully extend and adjust the position of the antenna. Note • To turn on/off radio, press RADIO. Store FM radio stations automatically You can store a maximum of 20 FM radio stations. 1 Press RADIO to turn on the radio.
» The clock radio stores all the available FM radio stations and broadcasts the first available station automatically. Store FM radio stations manually 1 2 Tune to an FM radio station. Press PROG . » The preset number begins to blink. 3 Press PRESET +/- or TUNING +/- repeatedly to select a number. Press PROG again to confirm. Repeat steps 1 to 4 to store other stations. 4 5 Note • To remove a pre-stored station, store another station in its place.
Note • Make sure that you have set the clock correctly. 1 Press and hold AL1/AL2 for 2 seconds to enter alarm setting mode. » The hour and minute digits begin to blink. or is displayed accordingly. » 2 3 Press HR+/- and MIN+/- repeatedly to set hour and minute. Press AL1/AL2 again to confirm. Select alarm sound For the alarm sound, you can select buzzer, your last heard radio or played track in iPhone/iPod. Adjust AL1/AL2 RADIO·BUZZ·iPhone to select alarm sound for both alarms.
• • To stop alarm, press the corresponding AL1/AL2 . The alarm repeats ringing for the next day. Snooze alarm When alarm sounds, press REPEAT ALARM . » The alarm snoozes and repeats ringing five minutes later. To adjust alarm interval (in minutes), press REPEAT ALARM repeatedly. 5 10 15 20 25 30 Set sleep timer This clock radio can switch to standby mode automatically after a preset period. Press SLEEP repeatedly to select the sleep timer period (in minutes). appears.
7 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2W RMS Tuner Tuning Range FM: 87.
General information AC Power Model: AS100-050-AE200; Input: 100-240 V ~, 50/60Hz, 2.0A 0.5A;Output: 5 V Operation Power Consumption <10 W Standby Power Consumption <2 W Dimensions - Main Unit (W x H x D) 130 x 78 x 146 mm Weight - With Packing - Main Unit 0.6 kg 0.4 kg 8 Troubleshooting Warning • Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself.
• Disconnect and reconnect the AC power plug, then turn on the unit again. Poor radio reception • Increase the distance between the unit and your TV or VCR. • Fully extend the FM antenna. 9 Notice This product complies with the radio interference requirements of the European Community. Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment.
this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with iPod or iPhone may affect wireless performance. iPod and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted.
2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ3270D_12_UM_V1.
