Always there to help you Register your product and get support at www.philips.
Contents 1 Important 3 2 Your clock radio 3 3 Get started 5 4 Listen to FM radio 6 5 Other features 7 6 Product information 9 7 Troubleshooting 9 Introduction What's in the box Overview of the clock radio Install battery Connect power Turn on Set time Tune to FM radio stations Store FM radio stations in memory Select a preset radio station Adjust volume Charge your mobile devices Set alarm timer Set sleep timer Specifications 8 Notice 3 3 4 5 5 5 5 6 6 6 6 7 8 8 9 10 EN 2
1 Important Warning •• Never remove the casing of this clock radio. •• Never lubricate any part of this clock radio. •• Never place this clock radio on other electrical equipment. •• Keep this clock radio away from direct sunlight, naked flames or heat. •• Make sure that you always have easy access to the power cord, plug or adaptor to disconnect the clock radio from the power. • • • • • • 3 Make sure that there is enough free space around the product for ventilation.
Overview of the clock radio a d b c e f g a Dock for charging mobile devices b SOURCE Turn on the clock radio. Switch the clock radio to standby mode. • Select FM radio source. g Display panel • Display current status. • • c PRESET/SET TIME • Store radio stations in memory. • Select a preset radio station. • Set time. d AL1/AL2/- VOLUME + • Set alarm. • Adjust volume. e HR/MIN/- TUNE + • Tune to FM radio stations. • Set hour and minute. f SNOOZE/SLEEP • Snooze alarm. • Set the sleep timer.
3 Get started Always follow the instructions in this chapter in sequence. Install battery The batteries can only back up clock and alarm settings when AC power is disconnected. Connect power Caution •• Risk of product damage! Make sure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. •• Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket. Never pull the cord. Connect the AC power adaptor to the wall socket.
4 Listen to FM radio Note •• Keep the clock radio away from other electronic devices to avoid radio interference. •• For better reception, fully extend and adjust the position of the FM antenna. Select a preset radio station In tuner mode, press PRESET repeatedly to select a preset station. Adjust volume While listening, press - VOLUME + to adjust volume. Tune to FM radio stations 1 2 3 Press SOURCE to turn on FM radio. Press and hold TUNE - or TUNE + for 2 seconds.
5 Other features • For Apple devices with a lightning or 30-pin connector: use the charging cable of the Apple device (not supplied) to connect the product with the mobile device as illustrated; Charge your mobile devices With this clock radio, you can charge your Android-powered mobile phone with a micro USB socket and Apple devices with a lightning or 30-pin connector. 1 Connect the clock radio with your mobile device.
Alarm source Alarm duration FM tuner/ Buzzer 30 minutes Set alarm timer You can set two alarms to ring at different time. Note •• You can only set the alarm in standby mode. •• Make sure that you have set the clock correctly. 1 2 3 4 Press and hold AL1 or AL2 for two seconds to activate alarm setting mode. »» The hour and minute digits blink. Press HR repeatedly to set the hour. Press MIN repeatedly to set the minute. Press AL1 or AL2 to confirm.
6 Product information •• Product information is subject to change without prior notice. Specifications Amplifier 500 mW Tuner (FM) Tuning Range Tuning Grid Sensitivity - Mono, 26 dB S/N Ratio Total Harmonic Distortion Signal to Noise Ratio 87.5-108 MHz 50 KHz <22 dBf <3% >50 dBA General information AC Power (Power Adapter) Brand name: Philips; Model: CS12F055150FGF; Input: 100-240 V~, 50/60 Hz, 500 mA; Output: 5.5 V 1.
8 Notice Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user’s authority to operate the equipment. local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. Note •• The type plate is located on the bottom of the apparatus. This product complies with the radio interference requirements of the European Community.
Specifications are subject to change without notice. 2015 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. AJ3250S_12_UM_V2.
