Clock Radio Register your product and get support at www.philips.
& % ^ # @ ! 0 4 9 7 8 $ 6 5 3 2 1
English Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
INSTALLATION POWER SUPPLY 1 Check if the mains supply, as shown on the type plate located on the bottom of the set, corresponds to your local mains supply. If it does not, consult your dealer or service centre. 2 Connect the mains lead to the wall socket. 3 To disconnect the set from the mains supply completely, remove the plug from the wall socket. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g.
RADIO You can use this set solely as a radio! 1 Adjust RADIO ON/OFF to ON to switch on the radio. 2 Select your waveband by adjusting the BAND switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO ON/OFF to OFF to switch off the radio. To improve reception: FM: extend and position the pigtail for optimum reception. MW: uses a built-in aerial inside the set. Direct the aerial by adjusting the position of your set.
SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 24 hour alarm reset option will be automatically selected after 59 minutes, from the time your alarm time first goes off. 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day: • Press ALARM RESET during the alarm call.
IMPORTANT! 1 During SLEEP activation, if you attempt to cancel SLEEP by pressing RADIO ON/OFF, the radio cannot be switched off. 2 To switch off, press RADIO ON/OFF and REPEAT ALARM (SLEEP OFF) alternately and repeatedly. CONNECTING AN EXTERNAL DEVICE You can listen to the sound of the connected external device through your AJ3231’s speakers. 1 Adjust the BAND (MW/FM/AUX) control to select AUX.
SAFETY INFORMATION • Install the unit near the AC outlet and where the AC plug can be easily reached. • Where the MAINS plug is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio.
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock.
ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
English Meet Philips at the Internet http://www.philips.
