Register your product and get support at EN User manual ZH-CN 用户手册 AJ3226
1 3 UP DOWN FM MHz MW KHz 5 x10 ALARM 1 0 ALARM 2 CLOCK RADIO AJ 3226 1 REP EA T ALARM SLEEP ALARM RESET •SLEEP OFF• 9 4 2 SET TIME SET AL CLOCK 1 SET AL2 OFF 6 7 8 @ AL 1 RADIO BUZ Z AL 2 OFF RADIO BUZ Z OFF BAND MW VOL TUNING FM AUX RADIO $ ! % ^ #
EN Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Controls (see fig.
i ALARM RESET • stops the active alarm for 24 hours j DISPLAY • show the clock/ alarm times and status of the set k OFF • RADIO • AUX • switches off the set or selects the radio/AUX mode.
3 To disconnect the set from the mains supply completely, remove the plug from the wall socket. Note •• The type plate is located on the bottom of the set. Clock memory backup The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g. mains failure. The complete clock radio and display illumination will be switched off. As soon as the mains supply returns, the display will indicate the correct time.
3 4 5 Adjust TUNING to tune to your desired station. Turn the VOLUME control to adjust the volume level. Adjust OFF • RADIO • AUX to OFF to switch off the radio. To improve reception: FM: extend and position the pigtail for optimum reception. MW: uses a built-in aerial inside the set. Direct the aerial by adjusting the position of your set.
Selecting the alarm mode GENERAL If you wish to use the alarm, you must first set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. • Select your choice of alarm mode by adjusting AL 1 or AL 2 to RADIO or BUZZ. »» The buzzers are at a set volume and cannot be adjusted. BUZZ on AL 1 is a low tone buzzer while BUZZ on AL 2 is a high tone. Switching off the alarm There are three ways of switching off the alarm.
Repeat alarm This repeats your alarm call at 6-7-minute intervals. 1 During the alarm call, press REPEAT ALARM/SLEEP OFF. SLEEP About Sleep This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 59 minutes. Setting SLEEP 1 2 3 • • Check that the clock control is in CLOCK position. Set OFF • RADIO • AUX to OFF position.
2 Connect the AUX-IN cable of the set to an AUDIO OUT or headphone jack on an external device (such as MP3 player, or CD player). Safety information • • • • • • • • • • • Install the unit near the AC outlet and where the AC plug can be easily reached. Where the MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable. Place the set on a hard and flat surface so that the system does not tilt.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like. Caution •• Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation. Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center.
Continuous crackling/hiss disturbance during MW broadcast – Electrical interference from TV, computer, fluorescent lamp, etc.
Specifications AC Power......................................................................................................220 V / 50 Hz Power Consumption Active............................................................................................................................... 5 W Standby.........................................................................................................................<2 W Dimensions (w x d x h)...........................................................
© 2011 Koninklijke Philips Electronics N.V. All rights reserved. AJ3226_93_UM_V1.
