XP AJ 3130/17.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 2 SAFETY Know these safety symbols CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. 2 This “bolt of lightning” indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering.
XP AJ 3130/17.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 4 IMPORTANT SAFETY INSTRUCTIONS – Read before operating equipment This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. 1. Read these instructions – All the safety and operating instructions should be read before the appliance is operated. 2.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 5 INDEX L’appareil répond aux normes FCC, Part 15. Fonctionnement soumis aux deux conditions suivantes: English FRANÇAIS ............................................... 16 ESPAÑOL ................................................. 26 Français 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. ENGLISH .............................................
XP AJ 3130/17.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 7 POWER SUPPLY Standby power consumption: ..................................................3W POWER BREAKDOWN BACKUP When a power failure occurs the complete clock radio will be switched off. When the power supply returns, the numbers on the display will start to flash and you will need to reset the correct time on the clock. English 1. Check if the power supply, as shown on the type plate inside the battery compartment, corresponds to your local power supply.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 8 SETTING THE CLOCK RADIO English CLOCK DISPLAY RADIO The time is displayed using the 12-hour clock system. Important! When setting the clock or alarm time, for accurate hour and minute adjustment always make sure you press the HR and MIN buttons separately and not simultaneously. You can use the clock radio solely as a radio. 1. Adjust the RADIO switch to ON. 2. Select your wave band using the BAND switch. 3. Use TUNING to find your radio station. 4.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 9 SETTING THE ALARM If you wish to use the alarm, first set the alarm time. There is a choice of two alarm modes, buzzer or radio. The display shows the alarm indicator if the alarm is set. 1. Adjust the clock control to SET ALARM. 2. Press and hold down the HR or MIN button to set and adjust the hours and minutes respectively: • With your finger held down on HR, the hour increases as a digit from 1 to 12.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 10 SETTING THE ALARM English Canceling the Alarm Completely • Before or during the set alarm time goes off, push the ALARM switch to OFF position. ™ Alarm indicator disappears from display. SLEEP About Sleep The clock radio has a built-in timer called SLEEP, which enables the radio to be automatically switched off after 59 minutes. SLEEP allows you to lie back, listen and fall asleep. Setting and switching off Sleep 1.
XP AJ 3130/17.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 12 LIMITED WARRANTY PORTABLE AUDIO 90 days Free Exchange This product must be carried in for an exchange. WHO IS COVERED? You must have proof of purchase to exchange the product. A sales receipt or other document showing that you purchased the product is considered proof of purchase. Attach it to this owner’s manual and keep both nearby. • • WHAT IS COVERED? Warranty coverage begins the day you buy your product.
XP AJ 3130/17.2 19-09-2000 12:28 Pagina 13 LIMITED WARRANTY EXCHANGING A PRODUCT IN U.S.A., PUERTO RICO OR U.S.VIRGIN ISLANDS... Contact your dealer to arrange an exchange. Or, ship the product, insured and freight prepaid, and with proof of purchase enclosed, to the address listed below. Small Product Service Center Philips Service Company 907 Snapps Ferry Road, Plant 2, Building 6 Greeneville,TN 37743 (In U.S.A., Puerto Rico and U.S.
