Register your product and get support at www.philips.
a b
c d SLEEP 15 30 60 OFF 90 120
e 1 2 PRESET/ SET TIME 2 sec HR 3 4 MIN PRESET/ SET TIME
f 1 2 RADIO ON/OFF TUNING 2 sec MIN 3 4 TUNING HR 2 sec VOLUME VOLUME
g 1 2 2 sec HR 3 4 MIN
h AL1 FM AL1
English 1 Important Read these instructions. Heed all warnings. Follow all instructions. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.
Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the disconnect device shall remain readily operable. 2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully & www.philips.com/welcome. What’s in the box (Fig. 3 ) Get started Always follow the instructions in this chapter in sequence. Install battery The battery can only back up clock and alarm settings.
Tip The display backlight is off when AC power is disconnected. Connect power (Fig. ) Caution Risk of product damage! Make sure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. Risk of electric shock! When you unplug the power adapter, always pull the plug from the socket. Never pull the cord. Note The type plate is located at the bottom of the clock radio. Set time (Fig. ) Note 4 You can only set time in standby mode.
Tune to FM radio stations (Fig. ) Store FM radio stations manually You can store up to 10 FM radio stations. 1 Tune to an FM radio station. 2 Press and hold PRESET for two seconds. » The preset number begins to blink. 3 Press TUNING repeatedly to select a number. 4 Press PRESET 5 Repeat steps 1 to 4 to store other stations. Tip To remove a pre-stored station, store another station in its place.
5 Other features Set alarm timer Set alarm Note You can only set the alarm in standby mode. When alarm sounds, volume rises gradually. You cannot adjust the alarm volume manually. Make sure that you have set the clock correctly. ; 0 ; AL1< AL2: set the second alarm. Tip The clock radio exits alarm setting mode when being idle for 10 seconds. Select alarm source You can select FM radio or buzzer as the alarm source.
Activate/deactivate the alarm timer Press AL1 or AL2 repeatedly to activate or deactivate the alarm timer. (Fig. » If the alarm timer is deactivated, the alarm indicator turns off. » The alarm repeats ringing for the next day. Snooze the alarm When alarm sounds, press SNOOZE. » The alarm snoozes and repeats ringing nine minutes later. Set sleep timer This clock radio can switch to standby mode automatically after a preset period. (Fig.
Tuner (FM) Tuning range Tuning grid " 6 @ =L Q " 2 6 " SL Q " 2 Total Harmonic Distortion " 2 87.5-108 MHz 50 KHz <22 dBf <51.5 dBf <3% >50 dBA General information ]^ 0 0 Operation Power Consumption " & 0 ^ Dimensions: @ ? ' ' Weight: -Main Unit -With Packing Brand name: Philips; @ < ]">`>6>L>6{{>|>} Input: 100-240 V~, 50/60 Hz; 0.15 A; 0.5 A Output: 6 V 5W <1 W 130 x 46 x 130 mm 0.26 kg 0.
7 Troubleshooting Warning Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains & 0 000 ? you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
8 Notice ] ' approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. This product complies with the radio interference ! { ^ Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
All registered and unregistered trademarks are property of their respective owners. =>= * # $# & { 2 All rights reserved. AJ3115_12_UM_V1.
