Clock Radio Register your product and get support at www.philips.
English SAFETY INFORMATION • Install the unit near the AC outlet and where the AC plug can be easily reached. • Where the MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio.
Notes for battery disposal Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed of with normal household waste. Please inform yourself about the local rules on separate collection of batteries. The correct disposal of batteries helps prevent potentially negative consequences on the environment and human health. Environmental information We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard.
Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
CONTROLS 1 DISPLAY - shows the clock/ alarm time and status of the set 2 ALARM indicator - lights up when alarm is activated 3 Frequency indicator - shows the radio frequency of your selected waveband 4 REPEAT ALARM / SLEEP OFF - switches off the active alarm for a 8-9 minute period - switches off the sleep function 5 CLOCK - sets the clock time 6 SLEEP - activates the radio for sleep function - adjusts the sleep period - stops the active alarm for 12 hours 7 ALARM RESET 8 ALARM - sets the alarm function 9
INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the plug to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e.g.
RADIO You can use this set solely as a radio! 1 2 3 4 5 Adjust RADIO / ALARM to RADIO ON to switch on the radio. Select your waveband by adjusting the FM/AM (MW) switch. Adjust TUNING to tune to your desired station. Turn the VOLUME control to adjust the volume level. Adjust RADIO / ALARM to OFF to switch off the radio. To improve reception: FM: Extend and position the pigtail fully to obtain optimal reception. AM (MW): uses a built-in antenna inside the set.
Helpful Hint: • If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. • The buzzer is set at a fixed volume and cannot be adjusted. SWITCHING OFF THE ALARM There are three ways of switching off the alarm. Unless you cancel the alarm completely, the 12 hour alarm reset option will be automatically selected after 1 hour and 59 minutes, from the time your alarm time first goes off.
SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 1 hour and 59 minutes. Setting SLEEP 1 Set RADIO / ALARM to OFF position. 2 Set the sleep time to activate sleep function by selecting on the following ways: • Simply press SLEEP to set your sleep time to 59 minutes.
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock.
© 2010 Koninklijke Philips Electronics N.V. All rights reserved. AJ3112_UM_61_V1.
