AJ3112_IFU_05_Eng 4/8/10 10:19 Clock Radio Register your product and get support at www.philips.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 2 1 1 2 @ ! 0 9 3 4 8765 ^ % $#
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 3 English Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. CONTROLS (see fig.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 4 Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. 2 Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type. 3 Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 5 INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the plug to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 6 RADIO You can use this set solely as a radio! 1 2 3 4 5 Adjust RADIO / ALARM to RADIO ON to switch on the radio. Select your waveband by adjusting the FM/MW switch. Adjust TUNING to tune to your desired station. Turn the VOLUME control to adjust the volume level. Adjust RADIO / ALARM to OFF to switch off the radio. To improve reception: FM: MW: Extend and position the pigtail fully to obtain optimal reception. uses a built-in antenna inside the set.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 7 SELECTING THE ALARM MODE To use the alarm, you must set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZ. ™ The alarm indicator (AL) will light up. Helpful Hint: • If you have selected the radio mode, make sure you have adjusted the volume loud enough to wake you. • The buzzer is set at a fixed volume and cannot be adjusted.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 8 REPEAT ALARM This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT ALARM / SLEEP OFF. ™ The alarm indicator (AL) will remain on. SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 1 hour and 59 minutes. Setting SLEEP 1 Set RADIO / ALARM to OFF position.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 9 SAFETY INFORMATION • Install the unit near the AC outlet and where the AC plug can be easily reached. • Where the MAINS plug is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the clock radio.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 10 TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 11 ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe local regulations on the disposal of packing materials and old equipment. Disposal of your old product Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 12 Specifications AC Power.............................................220 – 230 V / 50 Hz Power Consumption Active.........................................................................3.1W Standby......................................................................<2W Dimensions (w x d x h)...............130.4 x 130 x 46.8 (mm) Weight.....................................................................0.
AJ3112_IFU_05_Eng 4/8/10 10:19 Page 13 Meet Philips at the Internet http://www.philips.com W AJ3112 Printed in China AJ3112_UM_05_V4.0_1014.
