Register your product and get support at AJ1000 EN User manual
1 Important Safety a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
m Apparatus shall not be exposed to dripping or splashing. n Do not place any sources of danger on the apparatus (e.g. liquid filled objects, lighted candles). o Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning •• •• •• •• •• •• Never remove the casing of this apparatus. Never lubricate any part of this apparatus. Never place this apparatus on other electrical equipment.
Never dispose of your product with other household waste. Please inform yourself about the local rules on the separate collection of electrical and electronic products. The correct disposal of your old product helps prevent potentially negative consequences on the environment and human health. Environmental information All unnecessary packaging has been omitted.
2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this clock radio, you can: • enjoy the FM radio • know the time • wake up to buzz or favorite radio tone • set two alarms to ring at different time.
Overview of the main unit g 100 a h d e i j b c d e k f l a TUNING • Tune to a radio station. b REPEAT ALARM/SLEEP OFF • Repeat the alarm. • Disable the sleep timer. c SLEEP • Set the sleep timer.
d +/• e AL1, AL2 • RADIO: Set the current radio station as alarm tone. • BUZ: Set buzz as alarm tone. • OFF: Turn off the alarm timer. f VOL • Adjust the volume level of radio. g Display panel h AL RESET • Stop the alarm. i RADIO ON/OFF • Turn on or off radio. j BRIGHTNESS CONTROL • Adjust the brightness of display panel. k Clock Control • SET TIME: Activate the clock time setup. • SET AL1/AL2: Activate the alarm time setup; display the set alarm time. • CLOCK: Display the clock time.
3 Get started Caution •• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
Set the clock time 1 2 3 Switch Clock Control to SET TIME. Press +/- to set the time (24-hour system). Switch Clock Control to CLOCK. Tip •• Press and hold + to fast increase the time digits. •• Press - to decrease the time digits one by one. 4 Listen to radio Tune to a radio station 1 2 Press RADIO ON/OFF to turn on the radio. Adjust TUNING slowly to tune to a radio station. • To turn off the radio, press RADIO ON/OFF again. Adjust the volume level 1 Rotate VOL clockwise or anti-clockwise.
5 Set the alarm timer Set the alarm time You can set two separate alarms. For the alarm tone, you can select the buzz or the FM radio. Note •• Before you start, ensure that the time is set correctly. 1 2 3 Switch Clock Control to AL1 or AL2 (on SET AL1/AL2). Press +/- to set the alarm time. Switch Clock Control to CLOCK. Turn on the alarm timer Note •• Ensure the alarm time is set successfully. 1 Switch AL1/AL2 to BUZ or RADIO. »» / appears. »» The buzz or FM radio is set for alarm tone.
View the alarm time 1 Switch Clock Control to AL1 or AL2 (on SET AL1/AL2). »» or appears. »» The preset alarm time is displayed. Repeat alarm 1 When the alarm rings, press REPEAT ALARM/SLEEP OFF. »» The alarm repeats ringing 7 minutes later. Stop alarm ring 1 When the alarm rings, press AL RESET. »» The alarm stops but the alarm settings remain. Turn off the alarm timer 1 Switch AL1/AL2 to OFF. »» / disappears.
6 Other features Set the sleep timer You can set the clock radio to turn off automatically after a certain period of time (0 to 59 minutes). Note •• Before the setup, ensure Clock Control is switched to CLOCK and the radio is turned off. 1 Press and hold SLEEP. »» The time digits count down from 0:59 to 0:00. »» The radio turns on. 2 3 Press +/- repeatedly to adjust the time. Release SLEEP when the desired time digits are displayed. To turn off the sleep timer: 1 Press REPEAT ALARM/SLEEP OFF.
7 Product information Note •• Product information is subject to change without prior notice. Specifications Tuner (FM) Tuning Range 87.5 - 108 MHz Sensitivity - Mono, 26dB S/N Ratio < 22 dBf Total Harmonic Distortion < 3% Signal to Noise Ratio > 50 dB General information AC Power Input: 100-240V~ 50/60Hz 0.25MAX Output: 5VDC, 500mA Operation Power Consumption 3W Dimensions - Main Unit (W x H x D) 185 x 85 x 52 mm Weight - Main Unit 0.
8 Troubleshooting Caution •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/support). When you contact Philips, ensure that your apparatus is nearby and the model number and serial number are available.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. AJ1000_12_UM_V2.