User Guide

USING THE ALARM

GENERAL

Two different alarm times can be set. This can be useful when you need to be

woken up at a different time e.g. during the week and at the weekend:

• ALARM - radio mode

• ALARM - buzzer mode. The gentle wake buzzer alarm increases its beep tone

frequency within seconds.

SETTING THE ALARM TIME AND MODE

(See

)

1. Check the radio is switched off.

2. Press ALARM or ALARM to on.

™

Display: OFF

disappears under the respective

icon.

3. Press and

hold SET AL or SET AL until alarm time digits flash.

Hold down or press HR + or MIN + repeatedly to set and adjust the hours

and minutes respectively. Release HR + or MIN + when you have reached

the correct setting.

5. After both the hours and minutes are set, press

SET AL or SET AL

confirm the setting.

Helpful hints:

–

If you have selected ALARM , make sure you have properly tuned to a

station before turning off the set.

–

If you set and activate the same time for both alarms, only the ALARM will be

activate at the set time.

–

When both ALARM and ALARM are turned on, by default the display

shows the alarm time nearest to activtion.

–

To check the alarm time setting for ALARM or ALARM , press ALARM or

ALARM button.

–

It is not possible to adjust the alarm time during an alarm call or the repeat alarm

mode.

IFU_AJ100_eur_ENG 2006.11.10 13:42 Page 8