Always there to help you Register your product and get support at www.philips.
Contents 1 Important Important Safety Instructions 3 3 2 Your clock radio 4 4 5 3 Get started 6 6 7 7 4 Listen to FM radio 8 8 8 8 8 What's in the box Overview of the main unit Connect power Set time Turn on Tune to FM radio stations Store FM radio stations manually Store FM radio stations automatically Select a preset radio station 5 Other features 9 9 10 10 10 6 Product information Specifications 11 11 7 Troubleshooting 11 8 Notice 12 Set alarm timer Set sleep timer Play audio from an e
1 Important Important Safety Instructions a Read these instructions. b Keep these instructions. c Heed all warnings. d Follow all instructions. e Do not use this apparatus near water. f Clean only with dry cloth. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Warning •• Never remove the casing of this clock radio. •• Never place this clock radio on other electrical equipment. •• Keep this clock radio away from direct sunlight, naked flames or heat. •• To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. •• Ensure that you always have easy access to the power cord, plug or adapter to disconnect this clock radio from the power.
Overview of the main unit e a b c f g d h i k j AU D I O I N l m a SOURCE • Select a source.(FM/AUDIO IN) • Press and hold for 3 seconds to switch to standby mode. b SLEEP • Set sleep timer. c SNOOZE/BRIGHTNESS • Snooze alarm. • Adjust display brightness. d Display panel • Show current information. e AL1/AL2 • Activate or deactivate alarm timer. 5 EN f VOLUME +/• Adjust volume. g First Knob (HOUR/PRESET) • Adjust hour. • Select a preset radio station.
j BUZZ/FM/SOUND 1/SOUND 2 • Select an alarm source for Alarm 1 and Alarm 2. k • (5.0 V 1 A) Charge your iPod/iPhone through USB cable (not included). l AUDIO IN • Connect an external audio device. m FM ANT • Improve FM reception. 3 Get started Always follow the instructions in this chapter in sequence. Connect power The unit can only be powered by supplied AC power. Batteries are only used for alarm backup if not connected with AC power.
Option 2: Battery power Caution •• Batteries contain chemical substances, so they should Set time 1 be disposed of properly. Note •• Batteries are not supplied with the accessories. •• bAt shows on the display when the battery level is low. 1 2 3 Open the battery compartment. Insert 2 batteries (type: 1.5V LR6/AA) with correct polarity (+/-) as indicated. Close the battery compartment. 2 3 4 5 Rotate the Third Knob to "SET TIME" to activate clock setting mode. »» Hour and minute digits blinks.
4 Listen to FM radio 3 4 5 Rotate the First Knob again to select the target preset position. Press OK on the First Knob to confirm. Repeat steps 2-4 to store other stations. Note Tune to FM radio stations •• To remove a pre-stored station, store another station in its place. Tip •• Position the antenna as far as possible from TV, VCR, or other radiation source. •• For better reception, fully extend and adjust the position of the antenna.
5 Other features Set alarm timer ALARM In standby mode, you can set two alarms to ring at different time. Note •• Make sure that you have set the clock correctly. 1 2 3 4 5 2 Activate/deactivate alarm timer Note Rotate the Third Knob to SET AL1 or SET AL2 to activate alarm setting mode. »» The / and time digits blink. •• Make sure that the Third Knob switched to CLOCK before setting. •• This clock radio do not have 24H alarm reset function.
Set sleep timer Note •• Make sure that the Third Knob switched to CLOCK before setting. This clock radio can switch to standby mode automatically after a preset period. • Press SLEEP repeatedly to select the sleep timer period (in minutes). »» When the sleep timer is activated, appears. To deactivate the sleep timer: • Press SLEEP repeatedly until [OFF] (off) appears.
6 Product information 7 Troubleshooting Warning •• Never remove the casing of this device. Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 1W RMS Tuner Tuning Range Sensitivity - Mono, 26dB S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio FM: 87.
8 Notice Any changes or modifications made to this device that are not expressly approved by WOOX Innovations may void the user’s authority to operate the equipment. Notice for the USA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules and ICES-003 of Industry Canada . These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Specifications are subject to change without notice 2014 © WOOX Innovations Limited. All rights reserved. This product was brought to the market by WOOX Innovations Limited or one of its affiliates, further referred to in this document as WOOX Innovations, and is the manufacturer of the product. P&F is the warrantor in relation to the product with which this booklet was packaged. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. AH6000_37_UM_V1.
