Always there to help you Register your product and get support at www.philips.
Contents 1 Important 3 2 Your Bluetooth Adapter 3 3 Play 4 4 Product information 6 5 Troubleshooting 6 6 Notice 7 Introduction What's in the box Connect audio cables Connect power Enter pairing mode Play from Bluetooth-enabled devices Specifications About Bluetooth device Recycling 3 3 4 4 4 5 6 6 7 EN 2
1 Important • • • • • • • • • • • Read these instructions. Follow all instructions. Do not use this apparatus near water. Do not place near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. Only use attachments/accessories specified by the manufacturer.
3 Play Connect power Always follow the instructions in this chapter in sequence. Connect audio cables There are two ways to connect the Bluetooth adaptor to your Hi-Fi system. Select one fit for the Hi-Fi system. Option 1 (Fig. A) R Caution •• Risk of product damage! Make sure that the power supply voltage matches the voltage printed on the bottom of the unit. •• Risk of electric shock! Hold the plug securely when unplugging the device.
• If your Bluetooth device has been paired with the Bluetooth adapter before, press . »» The Bluetooth adapter attempts to connect the previously connected Bluetooth device. If it fails, the adapter returns to the pairing mode. 2 3 Tip •• If the Bluetooth adapter fails to pair with a Bluetooth device, the Bluetooth adapter exits the pairing mode in 2 minutes, and the LED light becomes dim. You can press to return to pairing mode.
4 Product information •• Product information is subject to change without prior notice. Specifications Amplifier Output Voltage Signal to Noise Ratio Total Harmonic Distortion 1000 mV RMS > 62 dBA <2% Bluetooth Frequency Band Range Bluetooth Standard Version 2.1+EDR 2.402~2.480 GHzISM Band 10m (free space) General information AC Power Warning •• Never remove the casing of this device. Note Standard 5 Troubleshooting Model: AS030-090EE033/EML0900330V (Philips); Input: 100-240 V ~, 50/60 Hz, 0.
Cannot connect with the device. •• The Bluetooth function of the device is not enabled. Refer to the user manual of the device for how to enable the function. •• The adapter is already connected with another Bluetooth-enabled device. Disconnect that device and then try again. •• The Bluetooth-enabled device might be cleared from pairing history. Follow steps below to re-pair: 1) Unplug the power for the product (AEA200) and then re-connect.
Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
2016 © Gibson Innovations Limited. All rights reserved. This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in relation to this product. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license from Koninklijke Philips N.V. AEA2000_12_UM_V5.
