AE2730_12_A_CCR 2008.6.24 10:00 Page 1 Portable radio Register your product and get support at www.philips.
AE2730_12_A_CCR 2008.6.
AE2730_12_A_CCR 2008.6.24 10:00 Page 3 Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of plug proceed as follows: 1. 2. 3. Remove fuse cover and fuse. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type. Refit the fuse cover. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.
AE2730_12_A_CCR 2008.6.24 10:00 Page 4 English Controls/Power Supply Congratulations on your purchase and welcome to Philips! To fully benifit from the support that Philips offers, register your product at www.philips.com/welcome. CAUTION High voltage! Do not open.You run the risk of getting an electric shock. The machine does not contain any user-serviceable parts. Modification of the product could result in hazardous radiation of EMC or other unsafe operation.
AE2730_12_A_CCR 2008.6.24 10:00 Page 5 Power Supply General Information Using AC power 1 Check if the power voltage, as shown on the type plate located on the rear of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the supplied switching adapter to the wall socket and the DC jack on the set. The set is now ready to use. 3 To switch the set off completely, withdraw the power cord from the wall socket.
AE2730_12_A_CCR 2008.6.24 10:00 Page 6 Basic Operation Radio/AUX Basic operation 1 Connect the supplied switching adapter to the wall outlet and the DC jack on the set or insert batteries as described in Power Supply. • Turn the source selector to TUNER to select tuner mode. • Turn the source selector to AUX to select AUX mode. ➜ The indicator light is lit in the previous two modes. • Turn the source selector to OFF to switch off the set. ➜ The indicator light is off.
AE2730_12_A_CCR 2008.6.24 10:00 Page 7 Safety & Maintenance (See 2) Safety & maintenance information • Place the set on a flat, hard and stable surface so that the system does not tilt. • Do not expose the set, batteries, CDs to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • The apparatus shall not be exposed to dripping or splashing.
AE2730_12_A_CCR 2008.6.24 10:00 Page 8 Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this will invalidate the guarantee.
AE2730_12_A_CCR 2008.6.24 10:00 Page 9 Meet Philips at the Internet http://www.philips.
