User manual

7
English
EN
Tip
•
When the main unit is powered by batteries, the
backlight turns on for 5 seconds after any operation.
Set clock
1 In standby mode, press and hold
SCAN/PROG for two seconds.
» [24H] or [12H] begins to blink.
2 Press + TUNING - to set the time format,
and then press SCAN/PROG to conrm.
» The hour digits begin to blink.
3 Press + TUNING - to set the hour, and
then press SCAN/PROG to conrm.
» The minute digits begin to blink.
4 Press + TUNING - to set the minute, and
then press SCAN/PROG to conrm the
clock setting.
Turn on
• Press to turn on the radio.
» The radio switches to the last selected
band.
• Press
again to switch the radio to
standby mode.
» The clock (if set) displays on the panel.