Register your product and get support at www.philips.
1 Important Safety Notice 2 Your Entertainment System Introduction What’s in the box What else you need Overview of the main unit Get started to use AirPlay 3 Prepare Connect power Turn AD6000W on 4 5 6 8 4 4 5 7 7 7 7 8 8 9 9 9 Connect to your home Wi-Fi network for AirPlay 10 Scenario 1: Connect to a WPS router 10 Scenario 2: Connect to a non-WPS router 11 Play 17 Update firmware 20 20 20 Stream audio from your iTunes music library to AD6000W 17 Control play 18 Use advanced sound settings 1
1 Important Safety Information for Europe: Know these safety symbols g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not remove the casing of this product. i Do not expose the product to dripping / splashing water, rain or high humidity. j Keep this product away from direct sunlight, naked flames or heat. k Do not install near any heat sources such as radiators, heat registers, stoves, or other electrical equipment (including amplifiers).
This product complies with the radio interference requirements of the European Community. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.
AirPlay, iPod, and iPhone are trademarks of Apple Inc., registered in the U S. and other countries. iPad is a trademark of Apple Inc. Class II equipment symbol: CLASS II apparatus with double insulation, and no protective earth provided. Note •• The type plate is located on the bottom of the apparatus.
Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the apparatus. Write the numbers here: Model No. __________________________ Serial No.
List of compatible iTunes host devices for AirPlay e MP3-LINK • Connect an external audio player through the supplied MP3 link cable. In terms of AirPlay, AD6000W is compatible with: • a Wi-Fi enabled PC/Mac installed with iTunes 10 (or later); and • the following iPod/iPhone/iPad models installed with iOS 4.3 (or later): • iPad 2 • iPad • iPhone 4 • iPhone 3GS • iPod touch (2nd, 3rd, and 4th generation) f DC IN • Connect the power adaptor.
Always follow the instructions in this chapter in sequence. Turn AD6000W on 1 Press on the back to turn the unit on. 2 Wait for successful boot-up of the unit. »» The boot-up takes about 35 seconds. »» During boot-up, the Wi-Fi SETUP indicator on the back of the unit blinks green quickly. Connect power »» After boot-up, if no Wi-Fi connection has been set up for AD6000W, the Wi-Fi SETUP indicator starts to blink green slowly.
4 Connect to your home WiFi network for AirPlay Before connection of AD6000W to you home Wi-Fi network, check the points below. 1 2 3 Make sure that your Wi-Fi router is powered on and working properly. Make sure that AD6000W has been powered on and booted up successfully (see ‘Turn AD6000W on’ on page 9). Identify the type of your Wi-Fi router (see the user manual of your Wi-Fi router for details).
The Wi-Fi enabled device can be an iPod touch/ iPhone/iPad or a Wi-Fi enabled PC/Mac. Follow the sequence below for connection of AD6000W to a non-WPS Wi-Fi router. 1 2 Tip 3 •• For some Wi-Fi routers, you may need to hold the WPS button for Wi-Fi connection or enable the WPS PBC function from the router configuration pages. See the user manuals of the specific routers for details. •• If the Wi-Fi SETUP indicator on AD6000W blinks yellow, it means that the Wi-Fi connection has failed.
1 2 3 4 Connect your Wi-Fi enabled device to your existing home Wi-Fi network. • Launch the Internet browser (for example, Apple Safari or Microsoft Internet Explorer) on your Wi-Fi enabled device. »» A new Wi-Fi network created by AD6000W will appear, with the network name (SSID) of Philips Fidelio AirPlay. Open the configuration page of your home Wi-Fi router.
Wait until successful Wi-Fi connection on your iPod touch/iPhone/iPad. »» is displayed at the upper left corner of your iPod touch/iPhone/iPad. Tip •• If Philips Fidelio AirPlay is not in the list, try to scan the available Wi-Fi networks again. Use your Wi-Fi enabled PC/Mac Note •• See the user manual of your PC/Mac for how to connect your PC/Mac to a Wi-Fi network. •• During Wi-Fi network connection, do not connect any network cable to your PC/Mac.
192.168.1.1 4 Wait until successful Wi-Fi connection on your PC/Mac. If you use Safari on your Wi-Fi enabled PC/ Mac, you can also select ‘Philips_Fidelio XXX’ from the Bonjour pull-down list to enter the AD6000W configuration web page directly. 1 Tip •• If Philips Fidelio AirPlay is not in the list, try to scan the available Wi-Fi networks again. Open the built-in web page of AD6000W 1 2 14 Launch Apple Safari browser or any other Internet browser on your Wi-Fi enabled device. Type in 192.168.1.
Tick Include Bonjour for Bookmarks bar. English 2 192.168.1.1 3 Select ‘Philips_Fidelio XXX’ from the Bonjour pull-down list shown at the bookmarks bar. »» The AD6000W configuration web page is displayed. • Follow the on-screen instructions to change and confirm the internal Wi-Fi settings of AD6000W. »» After a while, the indicator on the back of AD6000W stops blinking and stays green, and the unit beeps. »» AD6000W is connected to your existing home Wi-Fi network successfully.
Restore your Wi-Fi enabled device back to your existing home Wi-Fi setting 2 Select your network name (SSID) from the list of available wireless networks. Note •• Make sure that the settings at steps 2 to 3 below match your home Wi-Fi network settings you wrote on paper. 1 Select Settings -> Wi-Fi on your iPod touch/iPhone/iPad. • Or open the list of available Wi-Fi networks on your PC/Mac. 3 4 16 EN Enter the network key if required.
3 Select Philips_Fidelio XXXX (or user customized name) from the AirPlay list. English 5 Play Stream audio from your iTunes music library to AD6000W Note •• Make sure that your iTunes host device is connected to the same Wi-Fi network as AD6000W. Your iTunes device can be an iPod touch/iPhone/iPad installed with iOS 4.3 (or later) or a Wi-Fi enabled PC/Mac installed with iTunes 10 (or later).
Stream from your PC/Mac 1 2 Launch iTunes 10 (or a later version) on your PC/Mac. Click the AirPlay icon on the window. Tip •• When you stream audio from your iTunes music library on a PC/Mac, you can select more than one AirPlayenabled devices (if available) at step 3 to stream music to all of them at the same time. •• If you are using an earlier version of iTunes, the AirPlay icon may be instead of . Control play You can select different play options from either your iTunes host device or AD6000W.
Note •• The USB socket is only compatible with iPod/iPhone/ iPad. • • • • • • • • You can play or charge your iPod/iPhone/iPad through the USB socket with an Apple USB cable (not supplied). If you have stopped audio streaming by AirPlay, after successful USB connection, the unit switches to the USB source automatically.
6 Update firmware Update from the configuration page Warning •• Always connect your AD6000W to AC power for Note firmware upgrade. Never power off your AD6000W during firmware upgrade. •• You can only update the firmware from a PC/Mac. Note Download the update file •• To use an Internet browser other than Apple Safari on your PC/Mac, remember to go to the Wi-Fi router configuration page and write down the IP address of your AD6000W.
English 4 Follow the on-screen instructions to complete the firmware update. Note •• In case the firmware update fails, you can try the above procedures again. •• After successful firmware update, if there is any problem with the Wi-Fi connection, press and hold on AD6000W for more than 5 seconds to reset the device, and then try to set up the Wi-Fi network for AD6000W again (see ‘Connect to your home Wi-Fi network for AirPlay’ on page 10).
7 Product information Note •• Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power Frequency Response Signal to Noise Ratio MP3 Link Speakers Speaker Impedance Speaker Driver Sensitivity Wireless Wireless standard Wireless security Frequency range PBC (one button push) 22 EN 2 X 5 W RMS 63 Hz - 18 kHz, ±3 dB > 90 dB 600 mV RMS 20 kohm 8 ohm 66 mm full range 82 dB/m/W 802.
Warning •• Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www. philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available.
Occasional breaking of AirPlay music streaming Do one or all of the following: •• Move AD6000W closer to your Wi-Fi router. •• Remove any obstacles between AD6000W and your Wi-Fi router. •• Avoid using Wi-Fi channel which is overlapped by the nearby Wi-Fi network. •• Check if your network speed is fast enough (in cases where multiple devices share the same router, the AirPlay performance may be affected). Turn off the other devices connected to your home router.
© 2012 Koninklijke Philips Electronics N.V. All rights reserved. AD6000W_10_UM_V1.
