Quick start guide

5.X
4.3
Tap ALLOW (allow) to share your
Wi Fi settings with AD6000W.
Connect your iPod touch/iPhone/iPad
to your home Wi Fi network.
Your Wi Fi Network
Option 2: Set up through web page configuration
Option 1: Set up through Wi-Fi network login sharing (recommended)
Press WIFI SETUP to initiate
Wi Fi sharing.
Check your iOS version
Start to enjoy your AirPlay
4.3.X
SettingsGeneral About
Connect your iPod touch/iPhone/iPad to
AD6000W through an Apple USB cable
(not supplied).
Check that your router is
selected.
Tap to play music.
Select your device.
Your Wi Fi Network
Open Settings.
Wait for up to 1 minute until the light stops
flashing and you hear a confirmation tone.
If the AirPlay icon does not appear or there is no sound output,
try the following ways:
a
Turn on and off the Airplane Mode in Settings.
b
Restart your iPhone.
c
It is recommended to restart your home router.
Tap AirPlay icon .
Open iPod application.
Wait for 35 seconds until the green light
blinks slower.
Connect power.
If your Wi-Fi router has a WPS button, you can
connect the device to the router through WPS.
1. Press WIFI SETUP, then the light blinks yellow
and green alternately.
2. Press the WPS button on the Wi-Fi router.
3. Wait up to 2 minutes until the light stops
blinking and you hear a confirmation tone
Upgrade your iPod touch, iPhone, or iPad to
iOS 4.3 or above.
Note: Make sure that Wi Fi is enabled on your
iPod touch, iPhone, or iPad.
Before setup, you are recommended to upgrade
your iPod touch/iPhone/iPad to the latest iOS
version. For iPhone 4S users, please upgrade to
iOS 5.1 or above for optimal performance.
DC IN
DC IN
Connect power.
Wait up to 30 seconds until “Philips
Fidelio AirPlay” is detected. Then,
tap it.
Disable the 3G network.
Tap Wi Fi.
Philips Fidelio AirPlay
Press and hold Wi Fi SETUP for 5 seconds, then
the light alternates between green and yellow.
Wait for 35 seconds until the green light
blinks slower.
Wait< 30sec
Enter the IP address
192.168.1.1.
SettingsGeneral Network
Wait up to 2 minutes until the light stops flashing and
you hear a confirmation tone.
If the light does not turn solid
green after 2 minutes, power off
and power on to restart the
device, then repeat steps from
the beginning.
192.168.1.1
a
If it takes more than 2 minutes to see the screen of
step 9, try to turn on/off the Airplane mode (Settings
> Airplane Mode) and start from step 3 again.
b
If the problem remains, restart your iPhone and start
from step 3 again.
Open Settings.
Remember to turn on the
3G network after successful
AirPlay connection.
Open Safari.
Follow the on screen instructions to
configure the Wi Fi settings for the
device.
Wait< 1min
Wait< 1min
5sec
Philips Fidelio xxx
Wait 35sec
Wait 35sec
AD6000W_05_QSG-SafetyPage.indd 2 4/28/2012 5:57:18 PM