User manual

16
1 Switch off the purier and unplug it.
2 Place your ngers in the recesses of the
side panels and gently pull the bottom
part of the front panel towards you. Lift
the panel out of the hooks at the top of
the purier.
1
2
3 Remove the lters using the tag on the
lter. Take the lters by both sides and
gently deposit them into the house hold
trash bin.
Note
•
Do not touch the pleated lter surface, or
smell the lter as it has collected pollutants
from the air.
• Wash your hands after disposing of the used
lters.
7 Replacethe
filters
The lter replacement light ( ) indicates the
lters have to be replaced.
Note
•
If you remove the front panel for lter
changing while the purier is switched on, all
lights on the control panel will be off.
• Once the front panel is placed back to the
purier, all lights ash twice. Then, the purier
is off. Press the

button to switch on the
purier again.
Replace the activated carbon
lterandtheHEPAlter
Note
•
The activated carbon lter and the HEPA lter
are not washable nor vacuum cleanable.
Replace both the activated carbon lter and
HEPA lter when the
light goes on. This will
last for approximately 2 weeks.
On the last day of the 2 weeks, the purier
beeps every 30 minutes to inform you that the
lter needs to be replaced.
Tip
•
When you remove or insert lters, place the
purier against a wall for more stability.
Note
•
Insert the lters in the correct position.
• Make sure you place the lters in the order of
HEPA lter, activated carbon lter, and nally
the pre-lter.
• Make sure that the side with the tag is pointing
towards you.
EN