User Guide

3. PC with Internet access or downloaded Photo Frame software on PC.
Software update procedure:
1. After downloading, Unzip all the software file, and select correct software
update ZIP file.
2. Unzip all the software update files (6 files in total) onto the root directory of the
supported memory card.
3. Make sure Photo Frame is OFF and properly connected to DC power.
4. Insert the supported memory card into Photo Frame.
5. Power on Photo Frame; the software update will start automatically. During the
update, DO NOT remove the memory card or make new connections.
6. The Software update is complete when you see one of the following messages
on Photo Frame:
Photos stored on your memory card
Or if you memory card does not contain photos:
No photo on external memory
7. After software update is complete, remove the memory card.
8. Restart Photo Frame.
9. Congratulations! You have successfully updated your Photo Frame. You may
remove the software update files from the memory card now.
Troubleshooting:
In the event your software update is not successful, please make sure：
1. Your memory card is supported by current software.
2. All files are correctly unzipped to the root directory of the supported memory
card.
Note: If you have previously updated another Photo Frame with this memory
card, some files may have been changed by the update. Solution: Unzip the
files again from the PC to the supported memory card.
3. Make sure Photo Frame is properly powered during the entire update process.