User guide

MS-7592
FCC-B RADIO FREQUENCY INTERFERENCE STATEMENT
part 15 of the FCC rules. These limits are designed
О N1996
This equipment has been tested and found to comply with the limits for a class
В digital device, pursuant to part 15 of the FCC rules. These limits are designed
to provide reasonable pro-
tection against harmful in-
terference in a residential
installation. This equipment
generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the measures
listed below.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for
help.
Notice 1
The changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Notice 2
Shielded interface cables and AC power cord, if any, must be used in order to
comply with the emission limits.
VOIR LA NOTICE D'NSTALLA TION A VANT DE RACCORDER AU RESEAU.
F©
Micro-Star International
MS-7592
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including interference that
may cause undesired operation.
PART NUMBER
G52-75921XG-Q13