User guide

12 Use of the menus and the menu system
Options 2 menu
Setting the BNC connectors
This control allows you to select whether to set the
AV3 input of the 5
BNC connectors to RGB or Component. See Connect Peripheral
Equipment, p. 6.
& Select BNC SELECT with the cursor up/down.
é Press the cursor left/right to select:
-
RGB if you connected a device with RGB output (5 BNC connectors)
-
SCART if you connected a device with RGB with composite sync output
via scart. (RGB connectors + HD connector)
-
COMP if you connected a device with component output (CrPrYCbPb
connectors)
Setting a computer image to the correct RGB select screen
This control allows you to select the most appropriate RGB Select mode for
a moving image, such as video mode, wide mode or a digital broadcast.
& Select RGB SELECT with the cursor up/down.
é Press the cursor left/right to select one of the modes in order to display
the following signals correctly:
AUTO : automatically selects the suitable mode for the specifications of
input signals as listed in the table "Computer input signals supported by this
system", see p. 14.
STILL: to display VESA standard signals. Use this mode for a still image from
a computer.
MOTION: the video signal will be converted to RGB signals to make the
picture more easily viewable. Use this mode for a motion image from a
computer.
WIDE 1: when a 852 dot x 480 line signal with a horizontal frequency of
31.7 kHz is input, the image may be compressed horizontally.To prevent this,
select
WIDE 1.
WIDE 2: when a 848 dot x 480 line signal with a horizontal frequency of
31.0 kHz is input, the image may be compressed horizontally.
To prevent this, select
WIDE 2.
DTV: select this mode when watching digital broadcasting (480p).
Setting high definition images to the suitable screen size
This control allows you to set whether the number of vertical lines of the
input high definition image is 1035 or 1080.
& Select HD SELECT.
é Press the cursor left/right to select the correct HD mode:
- 1080A for special digital broadcasts (e.g. DTC 100)
- 1080B for standard digital broadcasts
- 1035I for Japanese "High Vision" signal format.
Setting the picture size for RGB input signals
This control allows you to select the picture size mode for RGB input
signals
ON or OFF.
ON: NORMAL and FULL can be selected for widescreen switching
OFF: TRUE and FULL can be selected for widescreen switching.
Note: Select
RESET in the OPTION 1 menu to reset all the OPTION 1 and 2
settings to the predefined factory values and settings.
BNC SELECT RGB
RGB SELECT
HD SELECT
PICTURE SIZE
OPTIONS2
J
SELECT
L M
ADJUST MENU RETURN
126 1023.2 en us 29-08-2002 15:05 Pagina 12