Flat Panel Television User Manual

20
VID
EO
3
2
1
S•VID
EO
AUD
IO
& Press the v key repeatedly or select Source in the Setup
menu (see p. 10) to select
AV1, AV2, HDMI (AV3), Side or TV
channels
, according to where you connected your devices.
é Press the cursor up/down.
“ Press OK.
Remark: Most equipment (decoder, recorder) carries out the switching
itself. This is however never the case with a computer connected to
the HDMI input.
b
v
Select
Ò
®
‡π
†
®
®
®
æ
B
AMP DVD/R TV SAT AUX
º
v
®
Record a TV programme
You can record a TV programme using your
recorders tuner without affecting your TV.
& Select the channel number on your recorder.
é Set your recorder to record.
See the handbook for your recorder.
Switching channel numbers on your TV does not
disturb recording !
Record a programme from
MONITOR OUT
You can record a programme on your recorder
from the TV tuner via
MONITOR OUT.
& Switch on the device.
é Select the channel or wanted device on your
TV and the correct input on your recorder.
“ Set your recorder to record.
You record the tuner channel of the TV or
selected device.
Do not switch channels or turn off your TV when
you are recording through
MONITOR OUT.
Record with your recorder
To select connected peripherals
Camera, Game or Camcorder
& Connect your camera, game or camcorder as shown.
é Connect to VIDEO 2 and AUDIO L 3 for mono
equipment. For stereo equipment also connect
AUDIO R 3.
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the
S-VIDEO input
1 and
AUDIO inputs 3.
Do not connect cable 1 and 2 at the same time. This
may cause picture distortion !
Headphone
& Insert the plug into the headphone socket L as shown.
é Press ¬ on the remote control to switch off the
internal loudspeakers of the TV.
The headphone impedance must be between 8 and
4000 Ohm.The headphone socket has a 3.5 mm jack.
In the Sound menu select
Headphone volume to adjust
the headphone volume.
Side connections