User Guide

1717
Multi channel Surround receiver
& Connect the audio cable to the multi channel Surround receiver
and to
AUDIO OUT L and R at the bottom of your TV 1.
é If you want the loudspeakers of your TV to act as centre
speaker, also connect an audiocable to the multi channel
Surround receiver and to the
CENTRE IN at the bottom of
your TV 2.
“ Select Centre Input On in the Source menu. See p. 9.
The loudspeakers of the TV will now only produce centre
sound, the loudspeakers connected to the audio receiver will
produce Surround Sound.The volume has to be controlled via
the multi channel Surround receiver.
Note: No sound will be heard when a TV channel or external source is
blocked via the Child lock menu (see p. 12).
R
L
VGA
L
R
2
CENTRE IN
AUDIO
OUT
1
Headphone
& Insert the plug into the headphone socket L as shown.
é Press ¬ on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.The
headphone socket has a 3.5 mm stereo jack.
In the Sound menu select
Headphone volume to adjust the
headphone volume.
R
L
VGA
CENTRE
IN
Press the v key on the remote control repeatedly, or select Source in the Setup menu (see p. 9) to
select
EXT1, EXT2, EXT3 or YPbPr according to where you connected your equipment.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
To select connected equipment
Use the scart to cinch adaptor (with the switch in the IN position) to connect temporary peripheral
equipment (camcorder, digital camcorder, game boy, ...) to
EXTERNAL3.
Note: do not connect the CBVS and Y/C connector of one device at the same time.
Supplied adaptor
2264.1 gb 19-12-2003 14:02 Pagina 17