Technical data

200WP7 LCD
71
15
25
2006-02-16
2006-02-16
590
Jason Wang
BRAND : PHILIPS
20.1" TFT UXGA LCD Monitor
(HUDSON 7-200WP7)
TYPE : 200WP7ES/00
GENERAL PRODUCT SPECIFICATION
4.1 Test conditions
Unless otherwise specified, this specification is defined
under the following conditions.
(1) Input signal : As defined in 3.3, 1600x 1200
non-interlaced mode (75K/60Hz), signal
sources must have 75 ohm output impedance.
(2) Luminance setting: controls to be set to 200 nits with
full screen 70 % duty cycle white signal
(3) Warm up: more than 30 minutes after power on with signal supplied.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 20 +/- 5 °C
4.2 Resolution:
Factory preset modes (15 modes)
Note: 1. Screen displays at 40 preset modes
2. Screen displays perfect picture at 15 factory-preset modes
3. Screen displays visible picture with OSD warning when input modes
are other then 22 preset modes
4.3 Brightness: >=300 nits (at panel color temperature, at center of the screen, set contrast
Item H.Freq.
(KHz)
Mode Resolution V.Freq.
(Hz)
Item H.Freq.
(KHz)
Mode Resolutio
n
V.Freq
.(Hz)
1 31.469 IBM VGA 10H 640x350 70.086 9 48.363 VESA 1024x768 60.004
2 31.469 IBM VGA 3H 720x400 70.087 10 60.023 VESA 1024x768 75.029
3 31.469 IBM VGA 12H 640x480 59.940 11 68.700 MACINTOSH 1152x870 75.000
4 35.000 MACINTOSH 640x480 67.000 12 63.981 VESA 1280x102
4
60.020
5 37.500 VESA 640x480 75.000 13 79.976 VESA 1280x102
4
75.025
6 35.156 VESA 800x600 56.250 14 75.0 VESA 1600x120
0
60
7 37.879 VESA 800x600 60.317 15 65.29 - 1680x105
0
60.0
8 46.875 VESA 800x600 75.000
8639 000 16908