Technical data

25
Go to cover page
200WP7 LCD
To Monitor
D-sub/DVI cable
DC 8~12V
To Printer port
Power
indicator
To Monitor
D-sub cable
DC 8~12V
To Printer port
Power
indicator
DDC Instructions
To Monitor
D-sub/DVI cable
DC 8~12V
To Printer port
Re-programming Digital DDC IC
Step 1: After initialize alignment box, connecting all cables and
box as shown in Fig. 24
Fig. 25
Step 2: Read DDC data from monitor
1. Click icon as shown in Fig. 25 from the tool bar to bring up
the Channels "Configuration Setup" windows as shown in Fig. 26.
Step 3: Modify DDC data (verify EDID version, week, year)
1. Click (new function) icon from the tool bar, bring up
Step 1 of 9 as shown in Fig. 28.
EDID45 DDC application provides the function selection and
text change (select & fill out) from Step 1 to Step 9.
Step 4: Modify DDC data (Monitor Serial No.)
Next1. Click , bring up Fig. 29. Then select Digital Signal as below
3. Click OK button to confirm your selection.
4. Click icon (Read EDID function) to read DDC EDID data from
monitor. The EDID codes will display on screen as shown in Fig. 27.
Fig. 29
Fig. 30
2. Select the DDC2Bi as the communication channel.
As shown in Fig. 26.
Fig. 26
Fig. 27
Fig. 28
Fig.24
Printer
Port
To Monitor
To PC
1=DVI connector
2=D-SUB connector
3=Power Plug
3
To Monitor
D-sub/DVI cable
DC 8~12V
2. Click to step7, bring up Fig. 30.Next
- Serial number can be filled up or be changed at this moment.
- Click Finish to exit the Step window.