Technical data

PIN No. SIGNAL
1Red
2 Green/ SOG
3Blue
4 Sense (GND)
5NC
6RedGND
7 Green GND
8BlueGND
9 DDC +5V
10 Cable detect (GND)
11 Sense (GND)
12 Bi-directional data
13 H/H+V sync
14 V-sync
15 Data clock
21
Go to cover page
200WP7 LCD
To Monitor
D-sub/DVI cable
DC 8~12V
To Printer port
Power
indicator
To Monitor
D-sub cable
DC 8~12V
To Printer port
Power
indicator
General
DDC Data Re-programming
Analog DDC IC, & EEPROM
Additional information
In case the DDC data memory IC or main EEPROMwhich storageall
factory settings were replaced due to a defect, the serial numbers have
to be re-programmed"".
It is advised to re-soldered DDC IC and main EEPROMfrom the old
board onto thenew board if circuit board have been replaced, in this
case the DDC data does not need to be re-programmed.
Additional information about DDC (Display Data Channel) may be
obtained f
rom Video Electronics Standards Association (VESA). Extended
Display Identification Data(EDID) information may be also obtained from
VESA.
1. An i486 (or above) personal computer or compatible.
2. Microsoftoperation system Windows 95/98 .
Y o Install the EDID_PORT_Tool under Win2000/XP.As
Fig.1.
A. Copythe "UserPort.sys" to C:\WINNT\system32\drivers(win2000)
C:\WINDOWS\system32\drivers(winXP)
B. Runnin
g"io.exe" everytime, Before you start to programming
edid data .
4. DDC 2BI-ISP TOOL:
Inclusion :
A. DDC2BI-ISP TOOL(3138 106 10396) x1 (as Fig.2)
B. Printer cable x1
c. (D-Sub) to (D-Sub) cable x2
D. D-SUB to DVI cable X1
Note:The EDID45.1EXE is a windows-based program, which cannot
be run in MS-DOS.
System and equipment requirements
ou havet
3. EDID45.1exe program .
Fig.2Fig. 2
Fig.1Fig. 1
Pin Assignment
Fig.3Fig. 3
Fig.4Fig. 4
Input analog D-SUB connector pin assignment
Fig.5
DDC Instructions
Pin No. Description
1 TMDS data2-
2 TMDS data2+
3 TMDS data2/4 shield
4NC
5NC
6 DDC clock
7 DDC data
8NC
9 TMDS data1-
10 TMDS data1+
11 TMDS data1/3 shield
12 NC
13 NC
14 +5V
15 Ground (return for +5V and H/Vsync)
16 Hot plug detect
17 TMDS data0-
18 TMDS data0+
19 TMDS data0/5 shield
20 NC
21 NC
22 TMDS clock shield
23 TMDS clock+
24 TMDS clock-
Input DVI-D connector pin assignment