Specifications

51
TPT1.0A LA
7. Alignments
7.2 Software Updrade With ISPWriter
A. Install
1. Run SETUP.exe in ISPWriter2 folder
2. Copy all files in ISP3Writer3 folder to ..\Program Files\Trident\
ISPWriter2
B. Use.
3Step
3.1 Trident tool(3138 106 10549)
Connect the PC with the UART_422 board by the RS232 cable and
connect UART_422 board "con2" to system board D_sub port. And
plug USB cable to PC.
3.2 P_Harmony tool (12nc=3138 106 10198)
Connect the PC with P_Harmony tool by the RS232 cable and connect
P_Harmony tool to system board D_Sub port. P_Harmony tool power on.
Yellow and Red led ON
4.RunISPWriter3.exe, you will see the below window (Diagram 1).
Press the OPEN button to open the COM port of the PC.
The COM port parameter can be set in Communication Settings
Dialog (Diagram 2).
By CommPort->Setting, the Communication Settings Dialog can be
opened, if the COM isnot opened.
5. Press the BIN button to select the bin file which will be programmed
into the flash.
The toolbar will be changed as Diagram 3.
5.1. (Configure)
Press the CONFIG button to open the Config Dialog(Diagram 4), in
this dialog, please select the correct CPU
Maker Chip and input
or select the correct StartAddress.
These information will be saved into the ISPWriter3.ini file. You can
directly edit the ISPWriter3.ini file by editing tool.
Diagram 4
6. Enter the ISP mode
You will see some information in the textbox when CPU enters the
ISP mode.
Just like below:
PH_ISP_VER003 , Please use ISPWriter3 !!!
ISPWriter3:
UART:115200,n,8,1
Version: 3.01
BuildTime:Apr 19 2006-11:10:51