Specifications

76
TPT1.2A LA
8. Alignments
8.2.8 Reboot
After finish the programming, AC power OFF à ON can
reboot the system.
CPU enters ISP mode by hardware way, if PC software (
ISPWriter3.exe) does not send any data during 30 seconds, the
CPU will leave ISP mode and go on to continue normal boot
operation (To run TV application).
When the system power-on, if the "Power" key on keypad is
pressed and be keep for 3 seconds, the CPU will enter ISP mode
and send information by UART.
Press the PROG button to start the programming.
8.2.6.1
8.2.6.2
8.2.7 Program
8.2.5 Press the BIN button to select the bin file which will be
programmed into the flash.
The toolbar will be changed as Diagram 3.
8.2.5.1 (Configure)
Press the CONFIG button to open the Config Dialog(Diagram 4),
in this dialog, please select the correct CPU
Maker Chip and
input or select the correct StartAddress.
These information will be saved into the ISPWriter3.ini file. You
can directly edit the ISPWriter3.ini file by editing tool.
Diagram 4
You will see some information in the textbox when CPU enters the
ISP mode.
Just like below:
PH_ISP_VER003 , Please use ISPWriter3 !!!
ISPWriter3:
UART:115200,n,8,1
Version: 3.01
BuildTime:Apr 19 2006-11:10:51
8.2.6 Enter the ISP mode