Specifications

Operations Manual

16 CONSOLE BASIC OPERATION

If the video (VGA) display card is disconnected or a video monitor is not used, you can still view information on the

LCD screen.

Figure 12: Single Scene Operation - LCD Display

Entering Single Scene Operation Mode

There are two ways of entering Single Scene mode:

If the SINGLE SCENE button is not lit at all:

1) Press the SINGLE SCENE button once and it will turn yellow.

2) Press the SINGLE SCENE button a second time and it will turn dark green.

3) You are now in Single Scene mode.

Note: Be aware that if any channels on PRESET A or PRESET B are above 0% and the relevant PRESET A or

PRESET B MASTER faders are at full the intensity of those channels will snap on.

Fading into Single Scene mode is also possible. If the SINGLE SCENE button is not lit at all:

1) Press the SINGLE SCENE button once and it will turn yellow.

2) If the PRESET A or PRESET B FADERS are at the bottom move them to the top. This will cross fade in

any channels set above 0% on the PRESET A faders and the SINGLE SCENE button will turn dark green.

3) If the PRESET A or PRESET B FADERS are at the top move them to the bottom and then move them to

the top. This will cross fade in any channels set above 0% on the PRESET A faders and the SINGLE

SCENE button will turn dark green.

In most cases during Single Scene operation you will only want to control 48 channels (24 channels on the 12/24

version) as this is the basic control mode. However it is possible to access up to 96 channels (48 on the 12/24 version)

by using the 1-48 (1-24) and the 49-96 (25-49) buttons. You can page between the pages to set the levels as you

require. Remember to re-page to lower these channels if you have set them. The LCD next to the channel numbers

you have selected will light to show which ones you are working on.

Setting a Scene

In Single Scene Mode you are able to crossfade between, or combine two scenes which are 48 channels wide (24

channels on the 12/24 version). To use this function, the NEXT button must be activated. This will allow the A

STORE and B STORE buttons to be used. Select the NEXT button and it will turn red.

A scene is set up using both the PRESET A and PRESET B faders (PRESET A faders control channels 1-24,

PRESET B faders control channels 24 - 48). This scene can then be stored temporarily by pressing the A STORE if

the PRESET A fader is at full or in the B STORE button if the PRESET B fader is at full.

A second scene can then be set up on the PRESET A and PRESET B faders. The A PRESET and B PRESET

MASTER faders can then be used to crossfade between the two scenes.

Release

DMX Base

A Fade

01:

13:

25:

37:

Master XXX

Single Scene

B Fade