Product guide

Sonos PLAYBAR

3. Use an awl or other sharp object to punch 4 small holes through 4 of the marked locations on the template. (If additional

reinforcement is desired, 2 spare screws and anchors are included in the wall mount kit.) Placement may vary but holes

should be located toward the corners, away from center.

4. Remove the template from the wall.

5. Drill pilot holes. 

Because the anchors and screws are designed to be self-starting, this step is optional. However pre-drilling will result in

a more accurate installation. Refer to the table below for more information.

Wall Material Pre Drill Use Wall Anchors Use Screws

Wood Stud

with 1/8” (3mm) bit No Yes

Drywall (no stud) with 3/16” (4.5mm) bit Yes Yes

Hard wallboard or double board with 3/16” (4.5mm) bit Yes Yes

Plaster with 1/4” (6.5mm) bit Yes Yes

Concrete or Brick with 1/8” (3mm) bit Yes Yes