Specifications

Mechanical Instructions
EN 8 L05U AA4.
Figure 4-4 Mono Carrier
Figure 4-5 Service position Mono Carrier
1. Disconnect the degaussing coil.
2. Release the two fixation clamps [1] (at the mid left and mid
right side of the bracket), and remove the bracket from the
bottom tray, by pulling it backwards [2].
3. Move the panel bracket somewhat to the left and flip it 90
degrees [3], with the components towards the CRT.
4. Turn the panel bracket with the rear I/O toward the CRT.
4.3 Assy/Panel Removal
4.3.1 Front Interface Assy/Panel
Figure 4-6 Front interface assy/panel removal
1. Remove the two fixation screws.
2. Remove the complete module from the bottom plate, by
pulling the two fixation clamps upward [1], while sliding the
module away from the CRT [2].
3. Release the two fixation clamps at the side of the bracket,
and lift the panel out of the bracket (it hinges at one side).
4.3.2 Side AV Assy/Panel
1. Remove the fixation screw, and remove the complete Side
AV assembly.
2. Release the two fixation clamps, and lift the panel out of the
bracket.
4.3.3 HDMI Interface Panel
To remove the HDMI Interface panel from the Mono Carrier,
unscrew the fixation screw at the back of the assy.
4.3.4 Trident Panel
1. Remove all cables.
2. Pull the panel upwards out of the connectors.
4.3.5 Top Control Assy/Panel
Figure 4-7 Top Control assy/panel removal
1. Remove the two fixation screws at the bottom [1] and the
two fixation screws at the front of the assy [2].
2. Release the two fixation clamps [3] to lift out the assy.
3. Release the two fixation clamps [4] to lift the panel out of
the assy.
F_15050_008.eps
110205
1
2
1
F_15050_009.eps
110205
3
F_15050_010.eps
110205
2
1
1
F_15050_012.eps
110205
4
3
2 2
1
1
3
4
L05U_AA_312278515051.book Page 8 Friday, March 4, 2005 10:42 AM