Specifications

Mechanical Instructions

EN 7L05U AA 4.

4. Mechanical Instructions

Index of this chapter:

4.1 Set Disassembly

4.2 Service Position

4.3 Assy/Panel Removal

4.4 Set Re-assembly

Note: Figures below can deviate slightly from the actual

situation, due to different set executions.

4.1 Set Disassembly

Warning: Be sure to disconnect the AC power from the set

before opening it.

4.1.1 Rear Cover

1. Remove all screws. If you do not remove them, you cannot

access the clips.

2. Tilt the set a little forward, so that you can release the two

clickfit clamps that are located at the bottomplate of the set.

3. Four openings (1) can be found at the top. The openings

are very small (2).

Note: Some sets only have the two inner openings.

4. Underneath every opening there is a clip. Push this clip

down with a very thin piece of metal (3), until you hear a

click.

Caution: do not use a screwdriver, this will damage the

cabinet.

5. When all four clips are pushed down, the back cover can

be removed.

Figure 4-1 Rear cover (for FL13 styling)

Figure 4-2 Opening

Figure 4-3 Pushing clips down

4.2 Service Position

Before placing the Mono Carrier in its service position, remove

the Front Interface assy/panel (see paragraph “Front Interface

Assy/Panel”) and the Side AV assy/panel (see paragraph “Side

AV Assy/Panel”).

E_13950_011 .eps

050404

E_13950_012 .eps

050404

E_13950_013.eps

050404

L05U_AA_312278515051.book Page 7 Friday, March 4, 2005 10:42 AM