Philips Business Display Solutions User Manual STOP Thank you for choosing Philips. Need help fast? Read your Quick Use Guide and/or Owner's Manual first for quick tips that make using your Philips product more enjoyable. If you have read your instructions and still need assistance, you may access our online help at www.bds.philips.com or call 1-866-358-9601 while with your product (and Model / Serial number) For Customer Use Enter below the Serial No. which is located on the rear of the cabinet.
TABLE OF CONTENTS Introduction Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . .3 Safety Information / Useful Tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Before Calling Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions.
SAFETY INFORMATION AND USEFUL TIPS SAFETY INFORMATION · Disconnect mains plug when : - the red light below the TV screen is flashing continuously. - a bright white line is displayed across the screen. - cleaning the TV screen. Do not use abrasive cleaning agents. Use a slightly damp chamios leather or soft cloth. - there is lightning or thunder storm - the set is left unattended for a prolonged period of time. · Do not place open flames near or on the TV. · Do not place TV set under direct sunlight.
BEFORE CALLING SERVICE Check this list of symptoms and suggested steps to take before requesting service. You may be able to solve the problem yourself. Note : Please become familiar with the commercial features as described in TV installation / Setup because the effects of several of these features, if not thoroughly understood might appear as faulty operation. SYMPTOMS SUGGESTED STEPS TO TAKE Installation TV does not 1.
BASIC TELEVISION CONNECTION ANTENNA CONNECTION · Connect the antenna or RF cable signal to the 75 ohm RF 'F' connector socket located on the TV's rear jack panel. MAINS CONNECTION · Ensure that the mains voltage and frequency are correct. Please refer to the product labelling and documentation. Note : The power button on the front panel does not disconnect the television from the AC mains. It toggles the TV between on and standby mode.
REAR JACK PANEL CONNECTIONS * WARNING : - Risk of electric shock. Rear jack panel must be removed by qualified personnel only. Do not connect telephone cable or equipment to SmartPlug Plug (R (RJ-12) connector. SmartCard slot & cover Note : 1. Do not connect Video In and S-Video simultaneously. 2.
REMOTE CONTROLS The following remote controls are applicable to Philips Business Display Solutions TV products. These can be used for setup and configuration purposes. POWER RECALL TEXT SMART SLEEP CC Slide this button up to enter into Guest mode. Slide this side button down to enter into Setup mode.
GUEST REMOTE CONTROL KEYS CH Guide To activate Channel Guide function Source Select To toggle between available video sources Close Caption To activate Close Caption function Standby Press to switch the TV off or on DVD Play To start DVD playback (if applicable) DVD Pause To Pause DVD playback DVD Stop To stop DVD playback (if applicable) Smart Sound To select predefined sound settings DVD Rewind To rewind DVD playback DVD Fast Forward To Fast Forward DVD playback (if applicable) Sleep Activate the sle
ACTIVATING TV SETUP MENU The following remote control commands are applicable to Philips Business Display Solutions TV products. These can be used for setup and configuration purposes. WITH GUEST REMOTE CONTROL RC2888/01 (only when SECURITY in the TV SETUP MENU is set to STANDARD. Refer to page 19). To activate TV SETUP MENU : 1 2 Select a channel number Key in 3 1 9 7 5 3 followed by the m button on the remote control.
TV SETUP MAIN MENU * LANGUAGE * CHANNEL INSTALL * CABLE TUNING • USE CHANNEL TABLE • DIGITAL TV LABEL • DTV SETUP * BRIGHTNESS * COLOR * CONTRAST * SHARPNESS * TINT * NOISE REDUCTION * SOUND MODE * SAP * AVL * BALANCE * TREBLE * BASS • AUDIO OUT FIXED • SPEAKER MUTE * INCREDIBLE STEREO * ULTRA BASS * VOLUME BAR • MIN VOLUME • MAX VOLUME • SWITCH ON VOLUME • SWITCH ON CHANNEL • POWER ON • CHANNEL DISPLAY • KEYBOARD LOCK • ESP • AUDIO/VIDEO MUTE * AUDIO/VIDEO OUT MUTE • MONITOR OUT RF • WELCOME MESSAGE • CHAN
TV SETUP MENU & SUB-MENUS * LANGUAGE (ENGLISH / ESPANOL / FRANCAIS) When you first enter the TV SETUP Menu, LANGUAGE is highlighted. Scroll to the LANGUAGE item, select other languages with the Æ or Í button on the remote control. * CHANNEL INSTALL > When selected, CHANNEL INSTALL menu appears. Configure the inputs and channels as seen here. INPUT 1 2 Select the channel or input you wish to configure. Select the channel or input you wish to associate with the specific CHANNEL.
TV SETUP MENU & SUB-MENUS (CONTINUED) · USE CHANNEL TABLE (NO / YES) If USE CHANNEL TABLE is set to NO. The digital tuner will ignore the Virtual Channel Table (VCT) information that is contained in the Program and System Information Protocol (PSIP) during channel installation or Direct Channel Command which is sent by the TV set. When VCT is ignored, the digital tuner will tune to the physical channel, Radio Frequency (RF) Channel.
TV SETUP MENU & SUB-MENUS (CONTINUED) * BRIGHTNESS / COLOR / CONTRAST / SHARPNESS / TINT (||||||||| 0 - 63, TINT |||||||| -31 - 31) Adjust the respective picture setting using the Æ or Í cursor. * NOISE REDUCTION (NO / YES)) If NOISE REDUCTION is set to NO. The noise reduction feature is disabled. If NOISE REDUCTION is set to YES. Video noise is reduced with minimum reduction in picture sharpness. * SOUND MODE (MONO / STEREO) STEREO) Select either STEREO or MONO sound modes.
TV SETUP MENU & SUB-MENUS (CONTINUED) · MIN VOLUME (||||||||||||| 0 - 63) 63) Specify the lowest volume setting possible by using the remote control or the TV front panel (if it is not locked out). This setting cannot exceed the MAX VOLUME. · MAX VOLUME (||||||||||||| 0 - 63) 63) Specify the highest volume setting possible by using the remote control or the TV front panel (if it is not locked out). This setting cannot be less than the MIN VOLUME.
TV SETUP MENU & SUB-MENUS (CONTINUED) · WELCOME MESSAGE (>) ( ) A welcome message (maximum of 20 characters, 2 lines) can be programmed to appear on the TV screen when the TV is powered on. The message remains on the screen until any button on the TV front panel or remote control is pressed. This is how to set the Welcome Message : When the WELCOME MESSAGE setup menu is highlighted. Press cursor Æ or Í on the remote control to invoke the WELCOME MESSAGE sub-menu.
TV SETUP MENU & SUB-MENUS (CONTINUED) REMINDER (NO / YES)) When REMINDER is set to YES, the current channel or input label will be displayed at the top of the TV screen. (eg. TV2, CVI, etc.). The channel number or input label (if a label has been assigned in CHANNEL INSTALL), and the current MUTE status (i.e. if sound is MUTED) will also be displayed when available. When REMINDER is set to NO, the reminder information will appear only when the channel or input label is changed.
TV SETUP MENU & SUB-MENUS (CONTINUED) Note 1 : Note 2 : Note 3 : When the SOURCE item is highlighted, press Æ or Í on the remote control to step through the signal sources (eg. tuner, AV2, S-VIDEO etc.) that are in the CHANNEL RING. The SOURCE item in the FEATURES MENU cannot be used to select RF (tuner)channels. The SOURCE item can only be used to select signal sources (eg. tuner, AV2, S-VIDEO, etc) that are in the CHANNEL RING.
TV SETUP MENU & SUB-MENUS (CONTINUED) SLEEPTIMER (OFF / 15 MIN / 30 MIN / 45 MIN / 60 MIN / 90 MIN / 120 MIN / 180 MIN / 240 MIN)) When the SLEEPTIMER is activated, the TV automatically powers down after the specified period of time. Note 1 : The SLEEPTIMER differs from ESP (Energy Saving Programmability) in that the SLEEPTIMER countdown is unaffected by any command from the remote control or front panel of the TV.
19.72” 20 T IT L E DRAW N BY TOLERANCE REVISION DATE UNITS 23.35” 27HT 4000D /27 DIMENSIONS r.ef PDF 8670 000 23831 COMMENTS INCHES PHILIPS BUSINESS SOLUTIONS 0104006.1400 0104006.1400 0.125 PBS ITV 27” 29.
19.8” 21 T IT L E DRAW N BY TOLERANCE REVISION DATE UNITS 22.83” 27HT 7210D /27 DIMENSIONS r.ef PDF 8670 000 23825 COMMENTS INCHES PHILIPS BUSINESS SOLUTIONS 0104006.1400 0104006.1400 0.125 PBS ITV 27” 28.
DEFINITIONS, ABBREVIATIONS D EFINITIONSACRYNYMS , A CRONYMS & & A BBREVIATIONS APAC Automatic Pixel Aging Correction. A technique whereby the image displayed on the television screen is periodically shifted slightly, for the purpose of minimizing plasma panel phosphor "burn-in" A/V Audio / video. BDS Bit Rate Business Display Solutions. See PBS.
DEFINITIONS, ACRYNYMS & ABBREVIATIONS D ,A ( CONT .) (CONT.) RJ-12 Registered jack 12. Modular telephone-style connector form factor with 6 electrical conductors. Router Technically, also known as a Layer 2 Switch. A switching hub that operates at the Data Link Layer (Layer 2), and builds a table of the MAC addresses of all the connected stations. RTSP Real-Time Streaming Protocol. Allows control of multimedia streams delivered, for example, via RTP (RFC 3389, Real-time Transport Protocol Payload).
CLEANING & CARE · To avoid possible shock hazard, please be sure that the television is unplugged from the electrical outlet before cleaning. · When cleaning the television screen, take care not to scratch or damage the screen surface (avoid wearing jewelry or using anything abrasive). Wipe the front of the screen with a clean cloth dampened with water. Use even, easy, vertical strokes when cleaning. · Gently wipe the cabinet surfaces with a clean cloth or sponge dampened in a solution of cool clear water.
INDEX 27HT4000D DIMENSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 MOVIE RATINGS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 27HT7210D DIMENSIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 MUTE, AUDIO / VIDEO . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 A N A/CH A/V SWITCH . . . . . . . . . . . . . . . . . . . . . . . . . . .
