Specifications

Mechanical Instructions
EN 6 LC4.31E AB4.
4.1.4 Cover Shield for IBO-zapper & SSB (37” and 42”)
Figure 4-5 Cover shield (37” and 42”)
Figure 4-6 Connector screws (37” and 42”)
1. Remove the rear cover from the set.
2. Very cautiously disconnect the LVDS cable [1] from the
SSB panel (see Figure “Cover shield (37” and 42”)”).
Notice that this connector is very fragile.
3. Unplug the black cable [2] going from the IBO zapper/SSB
to the Audio/STBY board.
4. Remove all other cables [3] from the IBO zapper/SSB.
5. Remove the fixation screws [4] that connect the top
shielding with the bottom shielding.
6. Remove the fixation screws [5] that connect the connector
plate to the frame.
7. Remove the fixation screws [6] that connect the shield to
the rear connector plate, see Figure “Connector screws
(37” and 42”)”.
8. Remove the fixation screws [7] from the connectors.
9. Remove the connector plate from the shielding.
10. Remove the upper part of the shield (with the IBO zapper
attached to it) from the lower part of the shield (on which
the SSB is located), by unhooking it from its brackets.
11. Disconnect the antenna connector [8] from the tuner, see
Figure “IBO zapper & SSB (37” and 42”)”.
12. Carefully unlock the locking mechanism of the FFC
connector [9] and remove the flatfoil cable (see Figure
“How to unlock an FFC connector”).
13. Finally, loosen four screws [10], and remove the IBO
zapper from the top shielding.
Figure 4-7 IBO-zapper & SSB (37” and 42”)
Figure 4-8 How to unlock an FFC connector
4.2 Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
• While re-assembling, make sure that all cables are placed
and connected in their original positions.
Be careful with the fragile LVDS cable.
G_16220_022.eps
090206
1
3
5
4
3
3
2
G_16220_023.eps
090206
7
7
66
G_16220_024.eps
090206
10
8
9
F_16040_038.eps
021105