Specifications
Table Of Contents
- Colour Television
- 1. Technical Specifications, Connections, and Chassis Overview
- 2. Safety Instructions, Warnings, and Notes
- 3. Directions for Use
- 4. Mechanical Instructions
- 5. Service Modes, Error Codes, and Fault Finding
- 6. Block Diagrams, Test Point Overviews, and Waveforms
- 7. Circuit Diagrams and PWB Layouts
- IBO Zapper Panel: MOJO
- IBO Zapper Panel: Flash Memory
- IBO Zapper Panel: Power Supply
- IBO Zapper Panel: Interface
- IBO Zapper Panel: Analog Back End
- IBO Zapper Panel: Front End
- IBO Zapper Panel: Common Interface
- Layout IBO Zapper Panel (Overview Top Side)
- Layout IBO Zapper Panel (Part 1 Top Side)
- Layout IBO Zapper Panel (Part 2 Top Side)
- Layout IBO Zapper Panel (Part 3 Top Side)
- Layout IBO Zapper Panel (Part 4 Top Side)
- Layout IBO Zapper Panel (Overview Bottom Side)
- Layout IBO Zapper Panel (Part 1 Bottom Side)
- Layout IBO Zapper Panel (Part 2 Bottom Side)
- Layout IBO Zapper Panel (Part 3 Bottom Side)
- Layout IBO Zapper Panel (Part 4 Bottom Side)
- 8. Alignments
- 8.1 General Alignment Conditions
- 8.2 Hardware Alignments
- 8.3 Software Alignments
- 8.3.1 ADC Gain and Grey Scale Alignment
- Table 8-1 ADC gain and grey scale alignment
- 8.3.2 Panel Size Settings
- 8.3.3 Options
- 9. Circuit Descriptions, Abbreviation List, and IC Data Sheets
- 10. Spare Parts List
- 11. Revision List
Circuit Descriptions, Abbreviation List, and IC Data SheetsEN 40 LC4.31E AB9.9. Circuit Descriptions, Abbreviation List, and IC Data SheetsIndex of this chapter:9.1 Introduction9.2 IBO Zapper 2 Module9.3 Block diagram IBO Zapper 2 Module9.11 Abbreviation List9.12 IC Data Sheets9.1 IntroductionThe LC4.31 chassis is a global chassis for the year 2006. It isthe successor of the LC4.3 chassis and covers screen sizes of26, 32, 37 and 42 inch (in 16:9 ratio). It has two new stylings,called ME5FL and ME6 (see front page). There are twodifferent picture qualities available, depending on the model:Pixel Plus in the xxPF7x21/10 models, and Digital Crystal Clearin the xxPF5321/10 and /12 models.The Digital Video Broadcasting (DVB) TV sets/modelsdiscussed in this manual are a combination of a standard TVset and an IBO Zapper 2 module.Note:• Only information that is related ito the IBO Zapper 2module is published in this manual. For the otherinformation, see the relevant chassis manual (order codeon front page).9.2 IBO Zapper 2 ModuleThe “IBO Zapper 2” module is meant to receive, process, andtransfer Digital Video Broadcasting-Terrestrial (DVB-T) signalsto the internal TV interface for audio, video, and control. The“IBO Zapper 2” is intended for use in combination with ananalogue TV chassis.Differences with respect to the earlier version of the IBO zappermodule are:• The PCMCIA connector is different.• The USB connector has been removed.9.3 Block diagram IBO Zapper 2 ModuleFigure 9-1 Block Diagram IBO zapper 2 moduleGATJEUIMLATXMARDSRI BSU 1C2I TESER 232SRXUMEDRCSEDoiduA-1GEPMredocedoediV-2GEPMredocedUPCOJOMxx38xnpTS inI2C0SmCard1SmCard0SPDIF I2S Analog Video OutMARDSBM61HSALFBM 4ni FHFIgolana C2I CGARENUT dirbyh6131DTFI latigid niFIrenut C2I CGAMDFOC64001tuoSTC2Ini STC2ItuoSTLORTNOCF/IUPC+hctaLreviecsnarT:)VT(yramirpcnysSBVC+)4:4:4(BGRro)4:4:4(rPbPY:)RCV( yradnucesSBVCoidua latigidoiduaCADR,L oiduagolana232SR/LTT232SRCGAC2IMORPEE)sgnittes resu(USPV21hctiws A/DGATJGATJ.I.CA0070VTSDSO-AICMCProtcennocFEH+XUMC2IV5QRIFI golanani FHeludom reppaZOBIffO/nOrewoPE_14970_036.eps011105
- 8.3.1 ADC Gain and Grey Scale Alignment










