Specifications

Remote Control and Receiver-Transceiver Specifications and Requirements
for Windows Media Center in Windows Operating Systems
91
CMD_SETIRRXPORTEN - Set IR Receive Ports
Message ID: CMD_SETIRRXPORTEN
Message length: 3 bytes
Message direction: Host to device
Offset
Name
Value
Description
0
CMD_PORT_IR
0x9F
IR command
1
CMD_SETIRRXPOR
TEN
0x14
Command ID - set IR receive
ports
2
P
Number
Port number to receive on
Description
This command sets the IR ports that are enabled for reception. If P == 1, then the long-range
receiver is used. If P == 2, then the wide-band receiver is used.
Response
Description
RSP_EQIRRXPORTEN
Returns the receiver number used for IR
reception.
No errors are returned to the host for this command.
CMD_FLASHLED – Flash the LED
EMVER_EMULATOR_V2 only
Message ID: CMD_FLASHLED
Message length: 2 bytes
Message direction: Host to device
Offset
Name
Value
Description
0
CMD_PORT_SYS
0xFF
System command
1
CMD_FLASHLED
0x23
Command ID – flash the LED
Description
When the device receives this command, it should flash its LED for two seconds.
Response
Description
RSP_FLASHLED
Successfully flashed the LED
No errors are returned to the host for this command.