Specifications

Remote Control and Receiver-Transceiver Specifications and Requirements
for Windows Media Center in Windows Operating Systems
129
Description
The device should return this response to the host if a write operation was attempted without
being proceeded by a proper CMD_WRITEAUTH request.
RSP_BOOT_BLOCKWRITTEN – Firmware Block Written
Successfully
EMVER_EMULATOR_V2 ONLY
Message ID: RSP_BOOT_BLOCKWRITTEN
Message length: 1 byte
Message direction: Device to host
Offs
et
Name
Value
Description
0
RSP_BOOT_BLOCKWRITT
EN
0x01
Response: block was successfully
written
Description
The device should return this response to the host when a block was successfully written to flash.
RSP_BOOT_BADSERIALCHKSUM – Bad Checksum in Firmware
Block
EMVER_EMULATOR_V2 ONLY
Message ID: RSP_BOOT_BADSERIALCHECKSUM
Message length: 1 byte
Message direction: Device to host
Off
set
Name
Value
Description
0
RSP_BOOT_BADSERIALCHECKS
UM
0xF0
Response: Bad checksum in
firmware block
Description
The device should return this response to the host if the checksum in the sent block was
incorrect.
Format for Transmitting and Receiving IR
This section contains information about formatting data for IR ports and for the Data End
message.
Data Format
Data for IR ports is encoded using a prefix byte and data bytes.