Specifications

Remote Control and Receiver-Transceiver Specifications and Requirements
for Windows Media Center in Windows Operating Systems
109
The following bit values can be OR‘ed together and returned in the WAKECAPS field.
Name
Val
ue
Description
DEVDETAILS_TIEDTOTUNER
0x0
1
The device is tied to a tuner (for instance,
the device is part of USB tuner/IR receiver
combination device)
DEVDETAILS_LEARNINGONLY
0x0
2
The device supports IR learning, but not
long-range IR reception
DEVDETAILS_NARROWBPF
0x0
4
Long-range receiver on the device has
narrow Band Pass Filter (BPF). Parse-
and-match remote identification is not
possible with the long-range receiver on
this device.
DEVDETAILS_NOINPUT
0x0
8
The device does not support IR input.
Long range receiver, if any, is only used
for parse-and-match remote identification.
DEVDETAILS_CANFLASH
0x1
0
The device supports the
CMD_FLASHLED command
DEVDETAILS_HASBOOTLOADE
R
0x2
0
The device has bootloader mode.
RSP_EQEMVER – Respond with the Interface Version used by the
Emulator
EMVER_EMULATOR_V2 ONLY
Message ID: RSP_EQEMVER
Message length: 3 bytes
Message direction: Device to host
Offset
Name
Value
Description
0
RSP_PORT_SYS
0xFF
System response
1
RSP_EQEMVER
0x22
Respond with the interface
version used by the emulator
2
EMVER
Number
Emulator version number
Description
This response allows the device to tell the host which version of the emulator interface the device
implements. If the device responds with EMVER_EMULATOR_V1, or if the device responds to
CMD_GETEMVER with RSP_CMD_ILLEGAL, the host assumes that the device uses the version