Specifications

Remote Control and Receiver-Transceiver Specifications and Requirements
for Windows Media Center in Windows Operating Systems
108
The following values are valid for the Protocol field:
Name
Val
ue
Description
V2_WAKE_PROTOCOL_RC
6
0x0
1
Wake key uses the RC6 protocol.
V2_WAKE_PROTOCOL_QP
0x0
2
Wake key uses the Quatro Pulse protocol.
The following values are valid for the Payload field:
Name
Val
ue
Description
WAKE_KEY_POWER_TOG
GLE
0x0
c
Button code for the Sleep toggle button
WAKE_KEY_DISCRETE_O
N
0x2
9
Button code for the discrete on button
The Address field should contain the address field in the wake pattern that it is listening for. Valid
values are 0-7 for RC6 and 0-15 for Quatro Pulse.
The Version field is only used when the wake pattern was programmed using the
CMD_BOOT_WRITEBLOCK method. When using this method, the Version number is extracted
from the firmware that was sent by the host. When not using this method, the Version number
should be returned as zero.
RSP_EQDEVDETAILS – Respond with Details about Device
Capabilities
EMVER_EMULATOR_V2 ONLY
Message ID: RSP_EQDEVDETAILS
Message length: 3 bytes
Message direction: Device to host
Offset
Name
Value
Description
0
RSP_PORT_SYS
0xFF
System response
1
RSP_EQDEVDETAIL
S
0x21
Respond with details about
device capabilities
2
DEVDETAILS
Number
Byte with bitmask of
DeviceDetailsBits values
Description
This is the response that the device uses to communicate its capabilities to the host.