Specifications

Design-in guide Philips Fortimo LED Line High Voltage System 7
Xitanium driver operating windows
The Xitanium drivers have a voltage and a current range, known as the 'operating
window'. This means that multiple combinations of LED Lines and drivers are
possible. The graph shows the operating windows of the Xitanium drivers.
The driver supplies a constant current to drive the LED Line. The correct current
setting can be chosen in three ways. If no resistance value is connected, this
automatically results in a 400 mA output current of the Xitanium driver.
1. The output current of the driver can be set by connecting a specific resistor
value to the driver. Philips supplies driver-to-board cables with integrated
resistors (Rset).
2. The OEM uses its own design of connector cables.
3. The Xitanium Touch/DALI TD drivers can be programmed in order to set the
desired current.
Philips LED Line cables
There are several cables available to suit your luminaire design.
Cables to connect the driver to the LED Lines without a resistor
Driver to LED Line cable 1C (for one chain of LEDs)
Driver to LED Line cable 2C (for two chains of LEDs)
The LED Line cables are designed to connect the Xitanium drivers to the LED Lines
1R, 2R and 3R. The length of this cable is 600 mm. If required, it can also incorporate
a resistor (Rset) that defines the output current of the driver. The cables without
Rset resistor are used if the Late Stage Configuration function of the driver is used.
Cables with and without Rset are available in 1-chain (1C) or 2-chain (2C) versions,
depending on the amount of modules you wish to connect to the driver. The cables
consist of a 7-pin connector on the driver side, and one or two 2-pin connectors to
connect the modules.
Chains of LED Lines
Cable
length
A
12 NC
LED Line cable 600 mm 1C HV
1 (1C)
600 mm
9290 006 90503
LED Line cable 600 mm 2C HV
2 (2C)
600 mm
9290 006 90403
Cables to connect the driver to the LED Line with a resistor
Driver to LED Line cable 1C with resistor
(for one chain of LEDs)
Driver to LED Line cable 2C with resistor
(for two chains of LEDs)
Rset
Ω
Chains of
LED Lines
Cable
length A
12 NC
LED Line cable 600 mm 232r
1C HV
232
1 (1C)
60 mm
9290 006 97803
LED Line cable 600 mm 619r
2C HV
619
2 (2C)
600 mm
9290 006 97703
LED Line cable 600 mm 464r
1C HV
464
1 (1C)
600 mm
9290 006 96003
LED Line cable 600mm 432r
1C HV NTC*
432
1 (1C)
600 mm
9290 006 79903
LED Line cable 600mm 590r
1C HV NTC*
590
1 (1C)
600 mm
9290 008 04903
 This cable includes an extra connector to be used for the Negative Temperature
Coefficient (NTC) resistor signal.