Specifications

Design-in guide Philips Fortimo LED Line High Voltage System 41
Step 3
Take bottom part of end-cap. A small boss is
visible on the bottom side.
Step 4
The small boss should be placed in the hole
indicated (hole number A2).
Push the small boss through this hole.
Step 5
Push the end-cap bottom part in the direction of
the arrow until the hole in the part is aligned with
the hole in the luminaire plate. Then insert a
screw and screw the part to the luminaire. The
screws used to secure the end-cap bottom to the
luminaire must be tightened.
It is advisable to apply a torque of 50% of the
maximum torque that is allowed for the applied
screw type in combination with the applied
material and material thickness.
Repeat step 5 for the other side of the LED line.
Screws
M4 Metric / M4 Taptite
Length ≥ 4 mm
Step 6
Mount the cables in the connector and guide them
through the holes provided.
For detailed information on wiring LED Lines,
consult the design-in guide for the LED Line.